2002 dodge intrepid

need alarm wiring for this vehicle thanks in advance.

DIRECTWIRE™ WIRING INFORMATION - DODGE / INTREPID / 2002 / Remote Start 12volts pink/black or red    +   ignition harness Starter yellow    +   ignition harness Second Starter           Ignition dk. blue/white    +   ignition harness Second Ignition GREEN/ red    +   ignition harness Third Ignition           Accessory BLACK/ orange    +   ignition harness Second Accessory BLACK/ white    +   ignition harness Keysense           Power Lock WHITE/ green   +   back of fusebox Notes: Locks are positive trigger through resistors. Use 2.7K (2700) ohms for lock and 620 ohms for unlock. MUST use relays. Can also use Directed 457C or 456L interface modules. Power Unlock same wire        Lock Motor orange      BCM Notes: BCM is located on the left side of dash with junction block. Unlock Motor dk. blue      BCM Notes: BCM is located on the left side of dash with junction block. Parking Lights+ do not use        Parking Lights- yellow      headlight switch Notes: Use a 110 ohm resistor to ground (-) for parking lights and a 220 ohm resistor to ground (-) will do both headlights and parking lights. Hazards           Turn Signal(L)           Turn Signal(R)           Reverse Light           Door Trigger tan and tan/red    -   BCM Notes: BCM is located on the left side of dash with junction block. Dome Supervision yellow   -   rear of fuse box, brown plug Trunk/Hatch Pin tan/black    -   drivers kick panel Hood Pin           Trunk/Hatch Release BLACK/ white    +   at release switch Power Sliding Door           Factory Alarm Arm lt. GREEN/ orange   +   drivers kick panel Notes: Arm is positive trigger thru a 1.87K ohm resistor, this will also lock the doors. Disarm is positive trigger thru a 680 ohm resistor, if use double pulse this will also unlock the doors. Must use relays. Can also use Directed 457C or 456L interface modules. Factory Alarm Disarm same wire        Disarm No Unlock           Tachometer        one of the coils Notes: This vehicle has an ignition coil for each cylinder. For tach use a tan/stripe wire at any one of the coils. Wait to start           Brake Wire WHITE/ tan    +   at brake switch Parking Brake           Horn Trigger BLACK/ red    -   steering column Memory Seat 1           Memory Seat 2           Memory Seat 3           Immobilizer Bypass Module: Required: Yes Type: Sentry Key Part #: 555C, 556U, or 555U Notes: Only vehicles with gray keys have the immobilizer.        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.