the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

96 maxima keyless entry


Post ReplyPost New Topic
< Prev Topic Next Topic >
dxplicitone 
Member - Posts: 10
Member spacespace
Joined: November 08, 2002
Location: United States
Posted: November 08, 2002 at 1:10 AM / IP Logged  

hello there..

im having some friggin issues with my girls 96 maxima...

what happened... i did the install on her system bulding the enclosure and amp rack for the car and of course had the battery disconnected for a short period of time running the power cables... okay this much is obvious... all done system done now.. and when i have everything back together now.. the friggin keyless entry no longer wants to work... i took it to nissan and the weak techs there told me the battery in the remote was dead... so to make them happy i bought a new one and then took it back for reprogramming... they cant program it for sh*t... its not responding... my understanding is that you have to put key in and out 5 times till hazzards flash... then after that.. im lost... how do i program it myself.. im about to kill nissan! i need to get this taken care of because lazy us we hate sticking the key in the hole nowa days. can anybody enlighten me here? thank you for your help.

whats this wire do ??? poof.. ohhhhh!
wired1 
Member - Posts: 7
Member spacespace
Joined: November 02, 2002
Location: United States
Posted: November 08, 2002 at 5:29 AM / IP Logged  

Try this. It may work, but I am not sure.

To reprogram (enter new ID) key fob (keyless remote controller) follow the steps.

1. Close all doors and lock all doors

2. Insert and remove the key from the ignition key cylinder more than six times within 10 seconds. (The hazard warning lamp will then flash.) Note: Key should be withdrawn from ignition key cylinder completely each time.

3. Insert key on ignition key cylinder and turn ignition key switch to "AAC" position At this time, the new ID code is entered and original (previous) ID codes are erase.

4. Push any button on the new remote controller once. (The hazard warning lamp will then flash) If there is only one remote controller skip step 5.

5. Additional ID code entry

Release the door lock, then lock again with door lock/unlock switch (In power window main switch)

6. Remove key from ignition

7. Unlock driver side door, open driver side door and then close the door. (END)

Note: -If you need to activate more than two additional new remote controllers, repeat the procedure on step 5 "Additional ID code entry" for each new remote controller. -Entry of maximum four ID codes is allowed and any attempt to enter more will be ignore.


Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Sunday, May 5, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer