resistors and LEDs

I am trying to hook up 2 LEDs(1.7v a piece)  to a sewing machine.  I do not know what size resistor I need to keep the LEDs from burning out.  I want to run them in a series form the lighting socket that is already there.  The only information I have on the socket is that it takes a 120v, 15 watt bulb.  I plugged this little bit of information into the ohm calculator and was told I need 960ohm resistor.  Does this I need one for each LED?  40oz. and a mule

I only claim knowledge in dc. Unless the sewing machine's light output is dc, which it probably isn't, then you can't use the leds. Just use a light.Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

I went to a local radio shack and got two different resistors, one rated at 680 ohms, the other at 1.2k ohm.  They both allowed the LED to stay lit without blowing.  Within 3 seconds the 680 got too hot to hold.  The 1.2 took at least 20 seconds but got just as hot.  I will not accept defeat there must be a way.40oz. and a mule

If no one knows a way around this, would a AA battery pack be easier?40oz. and a mule

Accept defeat or break out the marshmellows.Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Yes, a battery back would be much easier, since it will provide the DC your LED's require.  Otherwise you'd need a power supply.My ex once told me I have a perfect face for radio.

Fine, I will accept it, but not like it.  I rigged one LED to a flashlight that takes 2 AAs, and it was the perfect brightness.  If I used a battery pack with 4 AAs, for 2 LEDs would that change anything drastically, such as brightness, battery life, excessive heat, or anything?  40oz. and a mule

Did you try to add a diode in between the resistor and the led.

Ive never heard of anyone PIMPING A SEWING MACHINE!! Incredible what people think of. Could be the next big thing to have in your home. Neon manufactures started making kits for computers. I need to start manufacturing a LED kit for a sewing machine. I could make a fortune. LMAO!!    BTW, just because its AC doesnt mean you will SEE the flicker. The period of a 60Hz signal is 0.016 seconds. This is the same refresh rate a CRT computer monitor or standard TV uses. Its practically impossible to see the LED flashing. If you seriously want to get something working, e-mail me at: drvnbysound@aol.com and let me know. I will design something for you. I am about to get my BS in Electrical Engineering, Im sure I could come up with something.