Tools to makes holes in the dash

Home / the12volt's Install Bay / Miscellaneous - Off Topic / Tools to makes holes in the dash (

Topic Closed)

Welcome Guest :)

Members

< Prev Page < Prev Topic Next Topic >

dcash18

Member - Posts: 38

Joined: November 22, 2002

Location: United States

Posted: November 25, 2002 at 9:45 AM / IP Logged

Yeah, you can put it in a drill, but a drill only rotates at maybe1000rpm's and my dremel can go up to 20,000rpm's. It will be a rough cut putting a dremel bit in a drill

cpgoose

Gold - Posts: 1,098

Joined: July 08, 2002

Location: United States

Posted: November 25, 2002 at 9:48 AM / IP Logged

ahhh, i did not know that......i'm gonna check the rpms on my drill now :)

Aznpanther98

Member - Posts: 36

Joined: November 17, 2002

Location: United States

Posted: November 26, 2002 at 11:06 AM / IP Logged

it's easier with the dremel tool b/c depending on the size of it is easier to handle and u need the higher rpms to be able to make a good cut if on slower rpms it's gonna feel really choppy and sloppy i couldn't go without my dremel tool i've done tons of things with that that my saw, and drill couldn't especially cutting nails and steel screws

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Tools to makes holes in the dash

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.