the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

04 mazda 6 alarm wiring and tach wire


Post ReplyPost New Topic
< Prev Topic Next Topic >
leftyrev 
Member - Posts: 23
Member spacespace
Joined: August 20, 2004
Location: United States
Posted: May 03, 2005 at 10:42 PM / IP Logged  
looking for alarm wiring for a 04 mazda6 also looking for tach wire  , thanks
thepencil 
Silver - Posts: 1,529
Silver spacespace
Joined: December 16, 2002
Location: Canada
Posted: May 04, 2005 at 12:59 PM / IP Logged  
DIRECTWIRE™ WIRING INFORMATION - MAZDA / 6 / 2004 / Remote Start
12volts black (40A), BLACK/ yel (30A)   +   ignition harness
Starter BLACK/ blue   +   ignition harness
Second Starter N/A       
Ignition blue   +   ignition harness
Second Ignition N/A       
Third Ignition N/A       
Accessory BLACK/ red   +   ignition harness
Second Accessory BLACK/ white   +   ignition harness
Keysense WHITE/ blue   +   ignition harness
Notes: Using the status output from the remote start to trigger this wire will disarm the factory alarm without unlocking the doors.
Power Lock lt. green   -   driver kick or door lock module
Notes: Lock is negative trigger thru a 1000 ohm resistor. Unlock is a straight negative trigger. MUST use relays.
The door lock control module is located above the passenger kick panel.
Power Unlock same as power lock wire       
Lock Motor RED / blue   5wi driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Unlock Motor RED / green   5wi driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Parking Lights+ lt. GREEN/ black   +   driver kick, 14 pin plug
Parking Lights- RED / white   -   headlight switch
Hazards blue/orange   -   switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Turn Signal(L) WHITE/ black   +   turn signal switch
Turn Signal(R) WHITE/ red   +   turn signal switch
Reverse Light RED / yellow   +   driver kick, 14 pin plug
Door Trigger GREEN/ orange   -   driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Dome Supervision yellow/black   -   driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Trunk/Hatch Pin brown   -   driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Hood Pin gray/red   -   pin switch or theft module
Notes: The theft-deterrent control module is located in the center console.
Trunk/Hatch Release yellow   -   switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Power Sliding Door N/A       
Factory Alarm Arm blue   -   driver kick or door lock module
Notes: Arm is negative trigger thru a 1000 ohm resistor. Disarm is a straight negative trigger. MUST use relays.
The door lock control module is located above the passenger kick panel.
Factory Alarm Disarm same as factory alarm arm wire       
Disarm No Unlock use key sense wire       
Tachometer NOT blk/wht or grn/stripe   ac   any ignition coil or coil pack
Notes: On the 4 cyl models use the wire that is NOT BLACK/ white. On the 6 cyl models use the wire that is NOT GREEN/ stripe.
Wait to start N/A       
Brake Wire GREEN/ YELLOW   +   brake pedal switch
Parking Brake brown   -   parking brake switch
Horn Trigger PURPLE / white   -   switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Memory Seat 1 N/A       
Memory Seat 2 N/A       
Memory Seat 3 N/A       
Immobilizer Bypass Module: Required: Yes Type: Transponder Part #: 556U or 555U
Notes: N/A
      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
Be careful whose advice you buy, but be patient with those who supply it.posted_image
leftyrev 
Member - Posts: 23
Member spacespace
Joined: August 20, 2004
Location: United States
Posted: May 04, 2005 at 3:33 PM / IP Logged  
Thanks , I really apreciate it

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Sunday, September 24, 2017 • Copyright © 1999-2017 the12volt.com Donate to the12volt.com Advertising Top of Page
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Donate to the12volt.com
Top
the12volt.com spacer
the12volt.com spacer