Install problem on 92 honda integra, japanese

Home / the12volt's Install Bay / Car Security and Convenience / Install problem on 92 honda integra, japanese (

Topic Closed)

Welcome Guest :)

Members

< Prev Page < Prev Topic Next Topic >

Powermyster

Silver - Posts: 962

Joined: April 06, 2005

Location: Ireland

Posted: June 08, 2005 at 4:13 PM / IP Logged

OK i solved the problem it was so stupid of me i'm embarressed to post it. but i'm going to in the hope that people reading it will learn from my mistake.

All my wiring was right i knew that.

My first instincts the other night was a fuse was blown so i got the test light out(cos it was getting dark and its easy to see). i tested all fuses and they where ok. today i tried the door pin for continuity and it has0.9 so that was ok. I checked the fuses again with multimeter. one of the fuses read 12V on one side and 1.3V obviously enough to light the test light the other night.

moral of the story Always, Always use a DMM

would have saved me time. I hope somebody lears from this and my embarrassment is worth while

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Install problem on 92 honda integra, japanese

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.