Durango will not start after install

Home / the12volt's Install Bay / Car Security and Convenience / Durango will not start after install (

Topic Closed)

Welcome Guest :)

Members

< Prev Page < Prev Topic Next Topic >

rdlybeck

Copper - Posts: 81

Joined: June 30, 2005

Location: United States

Posted: July 20, 2005 at 10:43 PM / IP Logged

PS: Forgot to mention that I have removed the system I installed completely. All wires are intact as they were before I touched them. All fuses appear to test good. Any help would be very much appreciated!

Ryan Lybeck

"Wiring diagrams are nice but still double check with DMM"!

rdlybeck

Copper - Posts: 81

Joined: June 30, 2005

Location: United States

Posted: July 21, 2005 at 2:11 PM / IP Logged

I am using a wire from the possitive battery terminal to pin 87 of the starter relay. When I touch this wire to the relay the vehicle starts.

Ryan Lybeck

"Wiring diagrams are nice but still double check with DMM"!

rdlybeck

Copper - Posts: 81

Joined: June 30, 2005

Location: United States

Posted: July 21, 2005 at 5:52 PM / IP Logged

It is the factory starter relay. I have removed all rs relays and wiring. The car is back to the way I found it except it will not start with the key.

Ryan Lybeck

"Wiring diagrams are nice but still double check with DMM"!

rdlybeck

Copper - Posts: 81

Joined: June 30, 2005

Location: United States

Posted: July 21, 2005 at 7:01 PM / IP Logged

Does the start wire from the ignition switch go through the firewall directly to the pdc or does it go somewhere else first?

Ryan Lybeck

"Wiring diagrams are nice but still double check with DMM"!

rdlybeck

Copper - Posts: 81

Joined: June 30, 2005

Location: United States

Posted: July 22, 2005 at 1:17 PM / IP Logged

Thanks to everyone for the help. I have fixed the problem. There were two blown fuses that were hiding on the back side of the fuse panel inside the dash. Replaced these and the truck now starts. So now I have to reinstall the system I took out. LOL. What a pain.

Ryan Lybeck

"Wiring diagrams are nice but still double check with DMM"!

nava94

Silver - Posts: 296

Joined: February 28, 2004

Location: United States

Posted: July 22, 2005 at 10:40 PM / IP Logged

Make sure you test the wires and know what your tapping into before you connect your wiring again.use a digital meter to test your wires.good luck.

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Durango will not start after install

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.