Resin & backing surface Question

Home / the12volt's Install Bay / Fiberglass, Fabrication, and Interiors / Resin & backing surface Question (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

realitycheck

Silver - Posts: 751

Joined: September 09, 2004

Posted: July 28, 2005 at 7:48 AM / IP Logged

Yeah one little trick I learned on that. Keep you a sander or grinder close by. As soon as that layer dries and your ready to lay your next one, cut those little things off.

Learning the trade one fiberglass creation at a time!

Back to Top

dornstac

Member - Posts: 20

Joined: July 26, 2005

Location: Canada

Posted: July 28, 2005 at 3:42 PM / IP Logged

that reminds me........I am going to have to trim this beast soon, I don't have cutting tool with my dremel, are they cheap? and what would I look for?

I have thought of using an angle grinder, I am not sure if that would be overdoing it though since I may send fiberglass everywhere! let me know what you guys do.

I am starting the other wheel well today, I believe that this one will go a lot better, I hope to have it fully finnished by the end of the night, that is if I have learn't as much as I think I have

-Respect

Back to Top

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Resin & backing surface Question

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.