Clifford G5 Cliffnet Wizard RPM Program

Home / the12volt's Install Bay / Car Security and Convenience / Clifford G5 Cliffnet Wizard RPM Program (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

ringojam

Copper - Posts: 215

Joined: June 10, 2003

Location: Manitoba, Jamaica

Posted: September 23, 2005 at 7:12 PM / IP Logged

I do everthing manual have had problems wit the cliffnet wizzard, some times i put the rpm wire to fuel injector wire this gives me a stong signal, these new g5 give problem with the tac signal . try and warm up the car good and reset the blackjack it should come on sooner.

Back to Top

bbowman

Member - Posts: 7

Joined: August 13, 2005

Posted: September 23, 2005 at 7:52 PM / IP Logged

I just got off of the phone with the guy that sold me the alarm, and he suggested the same thing (run tach wire to fuel injector). I guess I'm going to try that tomorrow. Little bit of a pain considering I'll have to take half of the inside of the car apart again tomorrow (not looking forward to that).

Not a biggie though. Will probably wire in an air horn to blast simultaneous with the alarm while I'm at it.

Back to Top

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Clifford G5 Cliffnet Wizard RPM Program

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.