the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Should I use 2 relays for fans and amps?


Post ReplyPost New Topic
< Prev Topic Next Topic >
ghart999 
Member - Posts: 1
Member spacespace
Joined: September 15, 2005
Posted: September 15, 2005 at 2:24 PM / IP Logged  
I need to power on 3 amps, 2 crossovers and 6 12V fans from my HU remote wire. If I run everything through the same relay, will hte fans introduce electrical noise into the system? Should I put the fans on a separate relay from the components? If I do 2 relays, will they be isolated from eachother coming from the same distro block? Thanks all.
gcorrea 
Silver - Posts: 436
Silver spacespace
Joined: May 22, 2004
Location: United States
Posted: September 15, 2005 at 5:42 PM / IP Logged  
i would go ahead and use two relays one for fans and one for the amps and crossovers. no you  could get power from the same source.
gcorrea
KPierson 
Platinum - Posts: 3,527
Platinum spaceThis member consistently provides reliable informationspace
Joined: April 14, 2005
Location: Ohio, United States
Posted: September 23, 2005 at 10:19 PM / IP Logged  

ghart999 wrote:
I need to power on 3 amps, 2 crossovers and 6 12V fans from my HU remote wire. If I run everything through the same relay, will hte fans introduce electrical noise into the system? Should I put the fans on a separate relay from the components? If I do 2 relays, will they be isolated from eachother coming from the same distro block? Thanks all.

You shouldn't worry about inducing noise on your remote wires.  You are adding a lot of stuff, and didn't give very much information.  You would need to figure out the current draw of the everything, and see if you can fit it on one 30amp relay (shouldn't be a problem).  The big problem will be making sure you use a wire big enough to support the current of the 6 fans and fusing it properly.

If you are using a distribution block (or any other 12 volt source in a car) then the voltage will not be isolated, as all voltage is generated by the alternator.

Kevin Pierson

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Wednesday, May 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer