
2005 Honda Civic SE remote start
Welcome Guest :)
 
	  
  
  
         
         
         hyperlite137 
		 Member - 
		  Posts: 17
		 
		 Joined: November 24, 2003
Location: Canada
 Posted: September 19, 2005 at 11:31 AM  / IP Logged		     
Hi can anyone get the wiring scematic for the a 2005 Honda Civic SE.
THanks
  
	   
  
         
         
         chungo 
		 Copper - 
		  Posts: 135
		 
		 Joined: December 31, 2003
Location: United States
 Posted: September 19, 2005 at 2:29 PM  / IP Logged		     
|  12volts |  white (40A)  |  +  |  ignition harness  |  |  Starter |  BLACK/ white  |  +  |  ignition harness  |  |  Second Starter |  N/A  |    |    |  |  Ignition |  BLACK / YELLOW  |  +  |  ignition harness  |  |  Second Ignition |  N/A  |    |    |  |  Third Ignition |  N/A  |    |    |  |  Accessory |  BLACK/ red  |  +  |  ignition harness  |  |  Second Accessory |  WHITE/ red  |  +  |  ignition harness  |  | Keysense |  RED / white  |  -  |  ignition harness  |  |  Power Lock |  WHITE/ blue  |  -  |  driver kick, door harness  |  |  Power Unlock |  WHITE/ green  |  -  |  driver kick, door harness  |  |  Lock Motor |  yellow/black  |  5wi |  DKP or back of fuse box, top left  |  |  Unlock Motor |  YELLOW /GREEN  |  5wi |  DKP or back of fuse box, top left  |  |  Parking Lights+ |  RED / black  |  +  |  back of fuse box, top middle  |  | Notes: Can also use RED / yellow (+) at the front of the fuse box, 18 pin plug, pin 15. |  |  Parking Lights- |  blue  |  -  |  switch or factory alarm plug  |  | Notes: The factory alarm plug is a green plug above the driver kick panel. |  | Hazards |  same as turn signal wires  |    |    |  | Turn Signal(L) |  GREEN/ red  |  +  |  turn signal switch  |  | Turn Signal(R) |  GREEN/  YELLOW  |  +  |  turn signal switch  |  | Reverse Light |  green  |  +  |  frt of fuse box, 18 pin plug, pin 1  |  |  Door Trigger |  see notes  |  -  |  frt of fusebox or factory alarm plug |  | Notes: The driver door is green, the passenger door is lt. GREEN/ red, and the rear doors are GREEN / WHITE. Use all three wires and diode isolate each.The factory alarm plug is a green plug above the driver kick panel. |  |  Dome Supervision |  GREEN/ red  |  -  |  back of fuse box, top right  |  |  Trunk/Hatch Pin |  red  |  -  |  frt of fusebox or factory alarm plug |  | Notes: The factory alarm plug is a green plug above the driver kick panel. |  |  Hood Pin |  N/A  |    |    |  |  Trunk/Hatch Release |  N/A  |    |    |  | Power Sliding Door |  N/A  |    |    |  |  Factory Alarm Arm |  factory remote only  |    |    |  |  Factory Alarm Disarm |  factory remote only  |    |    |  |  Disarm No Unlock |  factory remote only  |    |    |  |  Tachometer |  blue  |  ac  |  test tachometer connector  |  | Notes: The test tachometer connector is a two pin connector to the passenger side of the battery. |  | Wait to start |  N/A  |    |    |  |  Brake Wire |  WHITE/ black  |  +  |  brake pedal switch  |  | Parking Brake |  GREEN/ orange  |  -  |  Immobilizer Control Unit, pin 4  |  | Notes: The Immobilizer Control Unit is on the ignition key cylinder. |  |  Horn Trigger |  orange  |  -  |  switch or factory alarm plug  |  | Notes: The factory alarm plug is a green plug above the driver kick panel. |  | Memory Seat 1 |  N/A  |    |    |  | Memory Seat 2 |  N/A  |    |    |  | Memory Seat 3 |  N/A  |    |    |  
   | Interface Module: | Category:Immobilizer Bypass  | Required:Yes | Type:Transponder |  | Part #: 556HW |  | Alternate Part1 #: 556UW |  | Alternate Part2 #: 555I |  | Alternate Part3 #: 555U |  | Alternate Part4 #: DesignTech 20402 |  | Alternate Part5 #: DesignTech 29402 |  | Notes:  |  
  | 
  
	   
 
Follow the12volt.com 
Monday, November 3, 2025
• Copyright © 1999-2025 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.