Keyless entery 04 Silverado

I just installed a Micro (DLR4HD) into an  04 Silverado (2 door).  The door lock actuators with in without a problem and look damn good.  However, I have run into multiple wiring problems and need help from the PROS.

The keyless entry specs are as follows.

Red- 12v hot at all times

Black- Gound

White- (+)Parking Lamp

Yellow- (+)Ignition

ORANGE / Black- (-)Dome Lamp

Brown- (-) Horn

Orange- (-) Starter Disable

Grey- Aux

Grey/White- Aux

I need to know which wires all this needs to run and where to access them.  Aslo everything i have seen lists the Park lamps as (-), but my system has (+) what do I do.   

Sorry I just realized this is in the wrong place.  How do I move it.

tcss, thanks for the held I didnt know that was there.  I think I got it now.  So I just use the brown wire in the driver kick for the park lamp?

You asked which wires it needs to work.  All you need for it to work is constant, ground, and outputs.  If you want ignition controlled locks, wire that in too.  It just depends on what you want: parking lights, horn honk, etc. 

For parking lights, you have two options:

      you can wire a relay to reverse polarity: https://www.the12volt.com/relays/page1.asp

      or, you can find a thick brown wire under the hood that runs on the driver's side in a big loom under the hood from the fuse box.  Make sure it tests (+) with lights.