programming viper car alarm

Home / the12volt's Install Bay / Car Security and Convenience / programming viper car alarm (

Topic Closed)

Welcome Guest :)

Members

< Prev Page < Prev Topic Next Topic >

jagyro

Member - Posts: 19

Joined: September 19, 2005

Location: United States

Posted: September 29, 2005 at 11:59 PM / IP Logged

i was thinking about it right, but back just when installed it, it had the problem a whole lot. Like every time i tried starting it. They pulled the relay for the remote start the 500m xcrs modual and the problem went away. But a week later it started again. Do you think if they left the tach wire connected it could be screwing with the alarm? Or maybe the remote start portion is not disabled? If it isn't how would u disable it?

99 z28

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

programming viper car alarm

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.