Hopefully this will help you. First things fir you need to check if your car has a factory alarm. To do this roll down the drivers window close and lock all the doors. Lock them either with the drivers switch or the factory transmitter. Wait about a minute. Then reach in the truck and manually unlock the drivers door and open it. If the horn starts blaring and the lights flash, then congrats you have a factory alarm. This will come into play later on. For the actual wiring I'll goe through it harness by harness for you.
H1
Lt. GREEN/ Black, GREEN / WHITE, Yellow, WHITE/ Blue, Gray/Black, WHITE/ Red, and RED / White are not used.
Black : Ground Grab a ring terminal, star washer, and screw it to a piece of metal under the dash
White : Parking light Flash Green wire in 16pin harness to the left of the fuses setup for positive out put
4 Pin Satelite Harness
Blue Status output : If your truck has a factory alarm this wire goes to the keysense wire at the ignition harness which is GREEN/ YELLOW. That wire will register ground as soon as the key is put into the ignition.
Blue Purple and Pink wires are not used.
The Relay pack ( you know that big ugly this with all the wires)
The 2 red wires are constant power inputs put one to the WHITE/ blue and one to the red wires at the ignition harness.
The purple wire is the starter output which goes to the GREEN/ black wire in the truck.
The pink wire is the ignition #1 output. Hook it to the BLACK/ red wire at the igniton.
Pink/wire second ignition/second accy out put goes to blue / YELLOW in the truck.
Finally orange accessory output goes to WHITE/ green.
3 Pin Door lock harness
Green negative lock output goes to blue wire in an 18 pin plug in the drivers kick
Blue negative unlock output goes to green wire in the same harness as above.
Remote Start H2 Harness
BLACK/ white : Just ground whis wire. Neutral safety switch input
Violet/white : Tach input easiest place to get this one is at one of the fuel injectors. Basically if you look at the wires you'll see that they all have one wire that is the same color. You want to hook up to the other wire at one of the injectors.
Brown: brake shutdown input GREEN/ YELLOW in the same plug as the parking light wire is in. The wire will only read 12volt when you step on the brake.
Gray : Hood pin shut down : goes to the hood pin that they hopefully installed in your truck. Though I have seen many installed without this wire being hooked up. If you don't hook this up be careful about disconnecting/reconnecting the battery as the remote start may try to start up the truck.
Blue/white: second status output goes to the activation input of the bypass module.
Anymore questions just drop me a line JPTree on AIM cntrylvr01 on Yahoo
Cause I'm So white and nerdy...
First Class Certi-fried installer