wiring aux channel

Home / the12volt's Install Bay / Car Security and Convenience / wiring aux channel (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

Black Dak

Copper - Posts: 50

Joined: January 22, 2005

Posted: October 31, 2005 at 3:17 AM / IP Logged

Can someone tell me how to wire a relay to provide a ground using a latching relay with a signal from a trunk release wire on a Clifford 10.5 alarm? I need help fast and badly! My project is almost done, but need help with this part...

Back to Top

dualsport

Silver - Posts: 983

Joined: September 27, 2005

Location: United States

Posted: October 31, 2005 at 9:24 AM / IP Logged

Why do you need a latching relay? Do you need the output to stay grounded after it gets the momentary aux signal?

The links in the Basics/Relays shows all sorts of diagrams for relay configurations that might be helpful for you-

Back to Top

Black Dak

Copper - Posts: 50

Joined: January 22, 2005

Posted: October 31, 2005 at 1:10 PM / IP Logged

I need the output signal from the trunk release to act as an on/off switch. Pressing it once would provide a ground, prssing it again would break the circuit. I am off to search through the relay section, but if you know of a specific setup, please et me know. I admit I am just at the beginning of learning all this stuff...

Back to Top

kgerry

Platinum - Posts: 3,455

This member consistently provides reliable information

Joined: February 07, 2004

Location: Saskatchewan, Canada

Posted: October 31, 2005 at 1:40 PM / IP Logged

this has already been asked and answered in a separate post..... please dont pollute the system with multiple posts asking the same question.....

the aux out (channel 4) is a negative output that is programmable for latched or momentary or pulsed......

Kevin Gerry

Certified Electronics Technician

MECP First Class Installer

Owner/Installer

Classic Car Audio

since 1979

Back to Top

Black Dak

Copper - Posts: 50

Joined: January 22, 2005

Posted: October 31, 2005 at 1:44 PM / IP Logged

I apologize for that, it wasn't intended. I was just hoping that asking the question in a different way would generate different answers.

I read the answer about channel 4, and as soon as I locate my install manual, I'll be looking into that. Thanks!

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

wiring aux channel

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.