2006 uplander, relay diagram for bypass

hey guys im installing a remote starter in a 2006 chevy uplander and was wondering if any body has the relay diagram for bypassint the transponder i know it only takes one relay to do and i know we need the extra key head but im not sure were the wires go on the relay.any help is very appreciated.thanx1990 mustang rollin on 18 inch lexani firestars,custom stereo,twin turbo 5 litre

You'll need a relay and a good length of about 18ga wire.  wire up as follows take the wire and wrap it around the head of the key 5-6 times and tape it to the key so it doesn't go anywhere.  Then run the wire up to the key cylinder and again wrap it around the antenna on the key cylinder again 5 or six times.  Once you've done that the two ends of that wire, put one end on pin 30 of the relay and the other one to pin 87.  Pin 86 goes to constant +12volt.  Finally 85 goes to a ground when running or status output of the remote start system.Cause I'm So white and nerdy...

First Class Certi-fried installer

your a life saver thnks alot1990 mustang rollin on 18 inch lexani firestars,custom stereo,twin turbo 5 litre