Anti-Grind feature

I think if I am reading this manual correctly, it says I have a built in remote and with my limited knowledge, from the wording it appears all I need is a relay and I can hook it up.

Here is what the manual says: 

Can someone tell me, in order to have anti-grind cheaply, i just need this relay?

tia

Xt

So, I just hook up those two wires to the SPDT relay and thats it, no other wires?   Do i just tap into the ignition switch wire, that is also used for the RS too? Do i have to worry about diodes or anything like that.

thanks again, for the quick response.

Hi auex, thanks again for responding.

This unit is just a RS remote start, no alarm. I am definately not disputing what you are saying , as  i am not knowledgeable with this stuff at all but what I was reading about this stuff above,, it just says to hook those two wires up to a SPDT relay.

xttech

Let me try to repeat what auex said, this is really simple but has to be done this way.  Trust me, your instructions left out the part about your starter wire- they were not very detailed!

1.You have to cut your vehicles starter wire in two. 

2.Then the side of the wire that goes to the key side gets connected to pin 30 of the relay.

3.the other half of cut starter wire goes to pin 87a (The moter side)  Also on this side of the wire you need to connect the remote starter's "start" wire

4.Pin 85 to Ignition wire,

5.Pin 86 to ground output of system.

In case you ask, this has to be done this way so that when the vehicle has been remote started the relay is preventing you from cranking the starter with your key "Anti-Grind" When the vehicle is not running the relay will alow your starter wire to be powered with your key as normal.

Hope this helps!