trunk with remote control

If your car already has power trunk release ( electric motor ) then all you will need is a relay, but if you do not have factory power trunk you will have to use a trunk release solenoid to pull the cable that releases the trunk latch.

thank you Jeff  My car has a power trunk release.

its all.  thank you very much.

I'll go to buy a relay,

What kind of vehicle do you have. I can tell you how to wire up the relay in the next post.

My car is a Grand prix 94

The target wire is a BLACK/ WHITE at the trunk release switch. You will need to give this wire a momentary ( + ) signal. If your alarm / remote starter does not have a ( + ) output trunk release wire, you will need to install a relay that chages polarity. Wire up a relay like this:

• 86 + 87 - 12 Volts Constant
• 85 - trunk release wire form alarm or remote starter
• 30 - BLACK/ WHITE trunk release wire of Grand Prix

thanks a lot Jeff..

Your Welcome

Hey, I have a question.  If you need to get a solenoid, do you still need to get a relay? 

Also...

My alarm has a ( - ) accessory output.  Can I just hook that output wire to the positive wire on the trunk release solenoid?

thanks, 

Hi AcuraRacing, yes, you still need a relay. Connect the (-) accessory output to #85, connect 12V+ to #86 and #87, and connect #30 to the positive lead of the solenoid.  

the12volt