pats ring placement

Home / the12volt's Install Bay / Car Security and Convenience / pats ring placement (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

ed langdon

Member - Posts: 8

Joined: December 20, 2005

Location: United States

Posted: December 26, 2005 at 7:27 PM / IP Logged

I have 20001 ford excursion ,i installed ford gold system . Can't get the remote start to work , what is best way or place to put bypass ring ? I try it all - will start if you hold the right side of key to key hole .

Back to Top

Haku

Copper - Posts: 204

Joined: November 22, 2002

Location: United States

Posted: December 26, 2005 at 7:54 PM / IP Logged

What brand and model of bypass are you using, and did you program it correctly?

Hak

Siemens Autostart

Back to Top

Mike M2

Platinum - Posts: 2,652

Joined: June 29, 2005

Location: United States

Posted: December 26, 2005 at 8:34 PM / IP Logged

On Fords i use duct tape to hold the ring in place. Make it tight against the very front of the cylinder, so the plastic shroud actually touches it. Make the ring as small as can be around it.

Mike M2

Tech Manager

CS Dealer Services

Back to Top

Craig3708

Copper - Posts: 155

Joined: January 30, 2004

Location: Canada

Posted: December 26, 2005 at 9:24 PM / IP Logged

If your bypass has a ring on it, I usually remove the key cylinder and install it directly to the Pats unit. To do this use a small scratch awe and push on the little ball (bearing) on the bottom of the key cylinder, turn the key to the on position and pull out the cylinder, works every time.

Craig

Back to Top

ed langdon

Member - Posts: 8

Joined: December 20, 2005

Location: United States

Posted: December 27, 2005 at 10:18 AM / IP Logged

IT is a ford 1l3z19g365ab , what is best way to program ?

Back to Top

ed langdon

Member - Posts: 8

Joined: December 20, 2005

Location: United States

Posted: December 27, 2005 at 2:21 PM / IP Logged

the performed ring is too big to go inside or on the end .It is a ford part .

Back to Top

Craig3708

Copper - Posts: 155

Joined: January 30, 2004

Location: Canada

Posted: December 27, 2005 at 5:31 PM / IP Logged

If you can't find a spot to put the ring, cut the ring off, remove 4-5 inches of insulation on each wire, wrap and tape the wire to the cylinder. If you still don't know how to program, post again and I'll give some suggestions, but it should say in the installation instructions.

Craig

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

pats ring placement

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.