diagram for 98 grand prix gtp

Home / the12volt's Install Bay / Car Security and Convenience / diagram for 98 grand prix gtp (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

fst100

Copper - Posts: 60

Joined: September 06, 2005

Location: United States

Posted: December 31, 2005 at 3:02 PM / IP Logged

im looking for the wiring diagram and the passlock immobolizer part number for:

98 Pontiac Grand Prix GTP Auto

Currently i have the Viper 160XV Remote Start/Security, but I plan on just installing the remote start because the vehicle has a stock keyless entry/security. Again I'm looking for the wiring diagram for the GTP, where and what color the tach wire is, the ignition harness(es), and so forth aswill as the best possible places to solder/tap the viper onto the vehicle harness. the other request is the bypass module for the passlock and the wiring schematics for it. I do thank you guys for all of your help, i had alot of help from the past from the people on this site, my applause to you all.

p.s.-i have an AIr/Fuel Gauge i want to install, where is the O2 sensor signal wire located in the engine bay?

fst100

Copper - Posts: 60

Joined: September 06, 2005

Location: United States

Posted: January 01, 2006 at 10:22 AM / IP Logged

after much searching i realize that starting after 99+ that the grix's has the passlock III, i currently have a 98, would that mean that it has the passlock II on it? if so what DEI bypass module would i need to get pass it? i know for my 99 cavalier i needed a 555L, what part number from DEI would i need for the 98 grand prix? also i found the wire laout in the other forums, but my question was if i could just skip the viper security and just install the remote starter on the vehicle. thanks.

Mharvey

Copper - Posts: 76

Joined: October 27, 2004

Location: United States

Posted: January 01, 2006 at 10:43 AM / IP Logged

Battery	BROWN AND ORANGE	(+)	PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PINS 12/33 OF 40 PIN PLUG
Ignition 1	YELLOW	(+)	PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PIN 35 OF 40 PIN PLUG
Starter 1	BLUE	(+)	PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PIN 15 OF 40 PIN PLUG
All Door Trigger	BLACK/ WHITE	(-)	AT PLUG TOP OF FUSEBOX
Domelight Super	BLUE
LF Latch	RED	(-)	BECU PIN 14 OF A 16 PIN PLUG
RF Latch	RED	(-)	BECU PIN 23 OF A 28 PIN PLUG
LR Latch	GREEN	(-)	BECU PIN 11 OF A 28 PIN PLUG
RR Latch	BLUE	(-)	BECU PIN 16 OF A 16 PIN PLUG
Trunk Trigger	RED	(-)	BECU PIN 11 OF A 16 PIN PLUG
Hood Trigger	WHITE/ BLUE	(-)	HOOD PIN SWITCH UNDER HOOD
Alarm Disarm	ARMS WITH LOCKS
Alarm Arm	DISARMS WITH UNLOCK
Parking Lights	GREEN	(+)	AT THE BACK OF PARKING LIGHT UNDER HOOD

Headlights-Lo	BLUE/RED	(-)	IGNITION SWITCH HARNESS
Wipers-Lo	BLUE / YELLOW	(-)	IGNITION SWITCH HARNESS
Trnk Release	LIGHT GREEN	(-)	BECU PIN 13

Battery		BROWN AND ORANGE		(+)		PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PINS 12/33 OF 40 PIN PLUG
	Ignition 1		YELLOW		(+)		PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PIN 35 OF 40 PIN PLUG
	Ignition 2		LIGHT BLUE		(+)		PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PIN34 OF 40 PIN PLUG
	Accessory 1		GREEN		(+)		PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PIN 11 OF 40PIN PLUG
	Starter 1		BLUE		(+)		PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PIN 15 OF 40 PIN PLUG
	Starter 2		LIGHT BLUE		(+)		PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PIN 17 OF 40 PIN PLUG
	Anti-Theft Type		UNIVERSAL TRANSPONDER
	Anti-Theft Descript		THE KEY SENDS A RF SIGNAL TO THE BCM THROUGH A ANTENNA AROUND THE KEY CYLINDER
	Key Sense		BLUE/WHITE		(-)		IGNITION SWITCH HARNESS
	Neutral Safety		GREEN / WHITE		(-)		AT GEAR SELECTOR SWITCH
	Tachometer		WHITE		(AC)		PIN 9 AT THE DATA CONNECTOR
	Speed Sense		PURPLE		(AC)		ECU MODULE TO THE RIGHT OF GLOVE BOX PIN 14 OF A 26 PIN PLUG
	Parking Lights		GREEN		(+)		AT THE BACK OF PARKING LIGHT UNDER HOOD
	Brake Lights		RED / BLACK		(+)		BRAKE PEDAL
	Reverse Lights		RED		(+)		ECU PIN13
	Horn		YELLOW		(-)		STEERING COLUMN HARNESS

Power Unlock	LIGHT GREEN	(-)	POWER MASTER SWITCH IN DRIVERS DOOR
PowerLock	PINK	(-)	POWER MASTER SWITCH IN DRIVERS DOOR
Driver Mtr Unlock	RED	(REV)	ECU IN DRIVERS DOOR
Driver Mtr Lock	GREEN	(REV)	ECU IN DRIVERS DOOR
Pas Mtr Unlock	RED	(REV)	ECU IN PASSENGER DOOR
LF Window Up	RED / YELLOW	(REV)	DRIVERS DOOR SWITCH
LF Window Dn	RED / BLUE	(REV)	DRIVERS DOOR SWITCH
RF Window Up	BLUE / YELLOW	(REV)	DRIVER KICK PANEL
RF Window Dn	BLUE	(REV)	DRIVER KICK PANEL

Mharvey

Copper - Posts: 76

Joined: October 27, 2004

Location: United States

Posted: January 01, 2006 at 10:49 AM / IP Logged

im not for sure but i looked up the passlock immobolizer on bypasskit.com and they dont list 1 so i dont think you need 1

fst100

Copper - Posts: 60

Joined: September 06, 2005

Location: United States

Posted: January 01, 2006 at 10:52 AM / IP Logged

bypasskit.com is a reliable source i see? thanks Mharvey

fst100

Copper - Posts: 60

Joined: September 06, 2005

Location: United States

Posted: January 02, 2006 at 7:35 AM / IP Logged

could i still be able to just install the remote start area and not install the security aspect?

theglassman

Member - Posts: 2

Joined: December 07, 2005

Location: Canada

Posted: January 02, 2006 at 6:01 PM / IP Logged

i am doing a 98 grand prix tomorrow ,the 98 doesn't need a by-pass kit but there could an oem alarm .if it does you have to program the oem alarm to work with the remote.

fst100

Copper - Posts: 60

Joined: September 06, 2005

Location: United States

Posted: January 02, 2006 at 6:44 PM / IP Logged

hmm ic, could u let me know theglassman if u'd have to program the oem alarm to work with the remote? thanks in advance

fst100

Copper - Posts: 60

Joined: September 06, 2005

Location: United States

Posted: January 05, 2006 at 5:57 AM / IP Logged

*bump^

fst100

Copper - Posts: 60

Joined: September 06, 2005

Location: United States

Posted: February 08, 2006 at 7:59 AM / IP Logged

glassman, i sent a PM to you, thanks

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

diagram for 98 grand prix gtp

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.