Immobilizer light flash after RemoteStart

there is a prob.  light should be out...ive had the same prob with a dei peice, but it was a cadilac. i ended up using a key.

XS

Do you have the blue wire connected to the Remote Start (status) output or your alarm?

I had the same problem on my car and realized that i hadn't connected this wire to the correct wire.

Hope this helps

A

Yes, I did connect the blue wire to the remote start status outout. But it still doesn't turn off the immobilizer light on the dash.

so sad.

be careful when reading the instructions because of all the important bits and peices of info that dei gives you.  is there any way that you may have overlooked somthing?  i have not had to use one of these modules so the info in my library is limited, sorry