the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

amp cuts off


Post ReplyPost New Topic
< Prev Topic Next Topic >
97lonoma 
Member - Posts: 7
Member spacespace
Joined: April 26, 2006
Location: United States
Posted: May 09, 2006 at 4:19 PM / IP Logged  
ok i have a dually 3500 i just installed 2 10''  and a 1000.1 amp its all MASSIVE so i came in here and i looked under wireing woofers but it dosent matter how i wire them it cuts out when i put it up loud.. what can be the problem ? not enough juice from the batt ? .
gregory863 
Copper - Posts: 112
Copper spacespace
Joined: May 12, 2004
Location: United States
Posted: May 09, 2006 at 4:26 PM / IP Logged  
what year? truck  what make?  whats the impedance of your woofs. where did you ground
prophesybh 
Copper - Posts: 78
Copper spacespace
Joined: July 04, 2005
Location: United States
Posted: May 09, 2006 at 4:29 PM / IP Logged  
It could be alot of things but your going to need the post brands and model numbers of your audio equiptment for any one to start helping you
Don't Ask Questions When You Already Know The Answer!!!
97lonoma 
Member - Posts: 7
Member spacespace
Joined: April 26, 2006
Location: United States
Posted: May 09, 2006 at 4:31 PM / IP Logged  

gregory863 wrote:
what year? truck what make? whats the impedance of your woofs. where did you ground

2005 / chevy / to floor and scraped all paint off for a good ground

the speakers are massive heres the specs

amp cuts off -- posted image. 10 in. Subwoofer.

amp cuts off -- posted image. Dual 2.5 in. 4ohm, 4 layer voice coils with 54mm winding length on composite kapton / fiberglass former.
amp cuts off -- posted image. Conex spider, custom injected poly-mica cone with clear polymer to Illuminate Logo.
amp cuts off -- posted image. High current woven silver plated tinsel leads.
amp cuts off -- posted image. 1”tall rolled Santoprene surround for MASSIVE excursion.
amp cuts off -- posted image. Removable gasket allows Onsite Re-Coning.
amp cuts off -- posted image. 40mm. Peak to peak X-Max.
amp cuts off -- posted image. Dual Stacked 150 oz. Magnets, label plate with chrome finish.
amp cuts off -- posted image. Competition grade cast aluminum basket.
amp cuts off -- posted image. Molded ABS high ventilation label plate with chrome finish.
amp cuts off -- posted image. 600w RMS / 1200 Max.
amp cuts off -- posted image. New platinum plated 5 way binding post with push-in terminals accommodates 8 gauge wires.

and the amp specs

amp cuts off -- posted image. 1000w RMS @ 1 Ohm / 1000w x 1 RMS / 2000w x 1 Max.

amp cuts off -- posted image. Dimensions 8.70" x 2.6" x 13.6"
amp cuts off -- posted image. Edge Lit Glass Strip features illuminated logo on Aluminum heatsink
amp cuts off -- posted image. Optional remote Bass Level control
amp cuts off -- posted image. EZ Link circuitry allows multiple Amps to link together
amp cuts off -- posted image. N-Channel Circuit for high-efficiency
amp cuts off -- posted image. Nickel plated precision connectors
amp cuts off -- posted image. Protect modes include thermal, short circuit, reverse voltage and over voltage
amp cuts off -- posted image. Proprietary “Bass Kompressor” circuitry provides low- frequency enhancement
amp cuts off -- posted image. Input sensitivity low level: 120mVrms ~ 5.0 Vrms
amp cuts off -- posted image. Frequency response: 8 Hz - 180 Hz
amp cuts off -- posted image. Lowpass: 40 - 180 Hz / 18dB

97lonoma 
Member - Posts: 7
Member spacespace
Joined: April 26, 2006
Location: United States
Posted: May 09, 2006 at 4:34 PM / IP Logged  
this is how is hooked up amp cuts off -- posted image.
gregory863 
Copper - Posts: 112
Copper spacespace
Joined: May 12, 2004
Location: United States
Posted: May 09, 2006 at 6:17 PM / IP Logged  
your specs on the woof said 4 ohm per voice coil the amp looks like it wants to see a 1ohm load. i've seen memphis amps that didn't work right at too high of an ohm load so try it at 1 ohm. that means run all 4 positives to the pos term of the amp then run all 4 negs to the amp neg. if that doesn't work try one of your friends woofs on your amp. also try reving the motor to about2500 rpms when you turn it up. 
danny boy 
Member - Posts: 14
Member spacespace
Joined: May 11, 2006
Location: Australia
Posted: May 16, 2006 at 7:22 AM / IP Logged  
do you have car on when it shuts of??
crzyvs

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, March 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer