Reverse wire, 2002 Toyota Sequoia

Home / the12volt's Install Bay / Vehicle Wiring Information & File Requests / Reverse wire, 2002 Toyota Sequoia (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

edrock200

Member - Posts: 23

Joined: October 26, 2004

Location: United States

Posted: May 11, 2006 at 7:42 AM / IP Logged

Hello all,

Looking for a reverse wire in my '02 Toyota Sequoia, preferably near the drivers side or somewhere near the front of the car if possible. I did a search and found another member stated that the BLACK/ red wire in a harness behind the drivers kick panel is the reverse wire.

(this thread https://www.the12volt.com/installbay/forum_posts.asp?tid=43998&KW=sequoia+reverse)

Unfortunately, when I meter out this wire when in reverse, park or drive it's always giving out +12v. I'm looking for a switched 12v that kicks on when the car is in reverse. Anyone know where I can find this wire?

Thanks in advance,

-Ed

Back to Top

edrock200

Member - Posts: 23

Joined: October 26, 2004

Location: United States

Posted: May 11, 2006 at 7:46 AM / IP Logged

Hmm now that I search some more it looks like the power unlock is also RED / black...can anyone tell me where the reverse red black wire is exactly in the tundra or sequoia? TIA,

_Ed

Back to Top

edrock200

Member - Posts: 23

Joined: October 26, 2004

Location: United States

Posted: May 11, 2006 at 9:59 PM / IP Logged

Anyone?

Back to Top

steve schofield

Member - Posts: 15

Joined: May 12, 2006

Location: United Kingdom

Posted: May 12, 2006 at 9:06 AM / IP Logged

I'm not sure if this will help you because I don't know the vehicle. However, I would start at the rear of the vehicle and work my way forward. Remove the bulb holder for the reverse signal lamp. Test for 12V+ at the holder when in reveres to detect the correct wire and follow the loom forward to the front of the vehicle. Normally under the carpets, under the door step trims. They usually just pull off but as I say, not knowing the vehicle I wouldn’t like to suggest you pull something too hard! Anyway, check the same colour cable in the kick well up front, just in case the colour has changed. If so, go back and follow the loom looking for a plug where the change has taken place and trace forward again. Hope this helps!

Back to Top

Search for other posts by steve schofield

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Reverse wire, 2002 Toyota Sequoia

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.