Adding extra status LED

I have installed Viper 560XV and everything is wokring fine. I am thnking of adding one extra status LED just the same as the one with bright blue with two wires, blue and red.

My question is can I just add(connect) this extra LED's blue wire to the existing blue wires and red wire to the red ? without adding resistor ?, in other word, the parallel connection.

The reason why I want to add one more LED is depending on sun shine, only one LED is not easily visible.

Thank you in advance for you help.

Twelvoltz,

Thanks for the advise, I just want to make sure that in series connection

connet to the (+) from the brain to LED-1(+) connect to LED-1(-) to LED-2(+)

LED-2(-) connect to connct to the brain(-)

Is this right ?, I do not want to fry anything, no resistor is needed ?

Thank you again for your advise, very much appreciated

Twelvoltz,

Thank you again for your prompt reply.

Very much appreciated.