97 audi a6 alarm/remote start

im gonna be doing a alarm w remote start and just wanted to know if i need to know any thing about it like door unlock and lock  any relays . left and right flashers how do i wire that and any thing with remote start any info what be apreciated thanks

12volts red    +   bottom of fusebox Starter RED / black    +   ignition harness Second Starter blue    +   ignition harness Ignition black    +   ignition harness Second Ignition           Third Ignition           Accessory yellow/black    +   ignition harness Second Accessory           Keysense           Power Lock BROWN / gray    -   door boot Power Unlock BROWN / green    -   door boot Notes: May require two pulses to unlock on some models. Also there is a single wire in the drivers door harness that toggles from (+) to (-) that can be controlled by relays - does not have the 3.5 second requirement, but also will not arm or disarm factory security. Lock Motor           Unlock Motor           Parking Lights+ gray/wht, gray/yel      behind fuse block Parking Lights-           Hazards           Turn Signal(L)           Turn Signal(R)           Reverse Light           Door Trigger brn/blk & brn/blu    -   at pins Notes: BROWN / black covers the drivers door. BROWN / blue covers all the other doors. Use both wires and diode isolate each. Dome Supervision use door trigger        Trunk/Hatch Pin RED / black    -   pin Hood Pin BROWN / red    -   pin or right of column Notes: Blue and black connector above relays to right of steering column. Trunk/Hatch Release RED / yellow    +   switch Power Sliding Door           Factory Alarm Arm arms on lock        Factory Alarm Disarm disarms on unlock        Disarm No Unlock           Tachometer yel, yel/red, or yel/grn   AC   coil - 2 cyl/each Notes: Also find lt.green at back of cluster - remove 5 screws to access. Wait to start           Brake Wire RED / black    +   brake pedal switch Parking Brake           Horn Trigger BLACK / YELLOW    +   relay under drivers dash There are 10 types of people in the world, ones that understand binary and ones that dont.

thanks for it info just wanted to know how 2 wire up the parking lights will i need relays or diode