merlon e330 alarm problems

Home / the12volt's Install Bay / Car Security and Convenience / merlon e330 alarm problems (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

el terror

Member - Posts: 33

Joined: June 07, 2006

Location: United States

Posted: June 08, 2006 at 9:55 PM / IP Logged

i installed an alarm its a merlon e330 and the problem im having is that when i try to set it to passive arming it wont stay on passive arming and just today the car doors were open and the alarm armed itself and then went off ( it activated) any ideas of what my problem might be? im thinking the alarm is defective what do you think?

auex

Platinum - Posts: 5,041

This member has made a donation to the12volt.com. Click here for more info.

Joined: December 23, 2002

Location: Arizona, United States

Posted: June 08, 2006 at 11:09 PM / IP Logged

Two things: either there is something wrong with the door trigger or there is an issue with the alarm. Some alarms will automatically passive arm after a set time regardless of the fact the door is open.

Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

JWorm

Platinum - Posts: 2,208

Joined: December 11, 2002

Location: New Hampshire, United States

Posted: June 09, 2006 at 12:12 AM / IP Logged

What wires in the car did you use for the door trigger? The symptoms you are describing indicate a problem with that part of the install. It could also be a problem with the alarm....it is a Merlon after all.

I'm also assuming this is about the RSX in your other post.

el terror

Member - Posts: 33

Joined: June 07, 2006

Location: United States

Posted: June 09, 2006 at 9:10 AM / IP Logged

well i checked all the connection and they are fine on the door triger its positive so i used a wire that goes directly to the dome light was that ok? im really thinking that there is going to be a problem w/ the alarm brain

el terror

Member - Posts: 33

Joined: June 07, 2006

Location: United States

Posted: June 11, 2006 at 12:37 AM / IP Logged

hey guys its me again i changed the brain on that mearlon (mea330) that i installed on the 98 crown victoria and everithing is working fine the only thing is that when i try to set it to pasive arming it just wont do it any ideas? im going to double check my connection on the door triger wire just in case.

el terror

Member - Posts: 33

Joined: June 07, 2006

Location: United States

Posted: June 12, 2006 at 7:14 PM / IP Logged

how esential is the hood pin that comes with the alarm im still not able to get the alarm to arm under pasive the thing is that i dint install the hood pin is that my problem?

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

merlon e330 alarm problems

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.