New to forums

Home / the12volt's Install Bay / Fiberglass, Fabrication, and Interiors / New to forums (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

fanatic

Member - Posts: 8

Joined: July 25, 2006

Location: United States

Posted: August 19, 2006 at 9:22 PM / IP Logged

I went ahead and cut to fit MDF for the floor. I then routed out the area where the tranny hump is to get a little more clearance. I have since started to fiberglass over the MDF to paint.

I already have the amps so that was out of the question. I will post pics or update as I go along.

Thank you for the help

Back to Top

fanatic

Member - Posts: 8

Joined: July 25, 2006

Location: United States

Posted: August 28, 2006 at 9:45 PM / IP Logged

1st and 2nd attempt failed. The 2nd attempt was looking ok but not what I had in mind. I am still open to suggestions. I am going to take some time and think about this some more to see if I can come up with another plan.

Back to Top

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

New to forums

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.