the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2004 eclipse remote start


Post ReplyPost New Topic
< Prev Topic Next Topic >
jraguilar 
Member - Posts: 3
Member spacespace
Joined: October 06, 2006
Location: United States
Posted: October 13, 2006 at 1:29 PM / IP Logged  
am puting a viper alarm on my eclipse and am looking for the wiring colors.. thanks
jraguilar
supra psych 
Member - Posts: 7
Member spacespace
Joined: December 24, 2003
Location: United States
Posted: October 13, 2006 at 7:00 PM / IP Logged  
What year is it? The eclipse has been around for some time and wire colors have most likely changed over the years.
supra psych 
Member - Posts: 7
Member spacespace
Joined: December 24, 2003
Location: United States
Posted: October 13, 2006 at 7:05 PM / IP Logged  
Sorry, I didn't see the year in the title. Hope this helps. It's for a 2004 eclipse remote start. Good luck.
12volts WHITE/ red (40A)   +   ignition harness
Starter BLACK/ red   +   ignition harness
Second Starter N/A       
Ignition green   +   ignition harness
Second Ignition N/A       
Third Ignition N/A       
Accessory blue/red   +   ignition harness
Second Accessory blue/black   +   ignition harness
Keysense blue/red      ignition harness
Notes: This wire rests at ground, and goes to an open circuit when the key is inserted into the ignition cylinder.
Power Lock purple   -   pin 33 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Power Unlock lt. GREEN/ red   -   pin 34 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Lock Motor lt. green   5wi pin 19, 28 pin plug below fuses
Unlock Motor GREEN/ red   5wi pin 22 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Parking Lights+ GREEN / WHITE   +   pin 2, 15 pin plug above fuses
Parking Lights- N/A       
Hazards green   -   pin 55 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Turn Signal(L) GREEN/ blue   +   pin 8, 15 pin plug above fuses
Turn Signal(R) GREEN/ YELLOW   +   pin 13, 15 pin plug above fuses
Reverse Light RED / blue   +   pin 9, 43 pin plug in driver kick
Door Trigger see notes   -   see notes
Notes: The driver door trigger is lt. green, pin 6, in a 15 pin plug above the fuses. The passenger door is lt. GREEN/ black in pin 65 at the ETACS ECU. Use both wires and diode isolate each.
The ETACS ECU is attached to the back of the fuse box.
Dome Supervision GREEN/ orange   -   pin 1, 3 pin plug above fuses
Trunk/Hatch Pin red   -   pin 62 or 37 at ETACS ECU
Notes: It is in pin 62 on the coupes, and in pin 37 on the convertible spyders.
The ETACS ECU is attached to the back of the fuse box.
Hood Pin GREEN/ red   -   pin 24 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Trunk/Hatch Release GREEN / WHITE   5wi pin 32 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Power Sliding Door N/A       
Factory Alarm Arm lt. GREEN/ black   -   pin 42 at ETACS ECU
Notes: Meter this wire while turning the key in the driver door key cylinder.
The ETACS ECU is attached to the back of the fuse box.
Factory Alarm Disarm orange   -   pin 25 at ETACS ECU
Notes: Meter this wire while turning the key in the driver door key cylinder.
The ETACS ECU is attached to the back of the fuse box.
Disarm No Unlock blue/red   -   pin 27 at ETACS ECU
Notes: Meter this wire while turning the key in the hatch/trunk key cylinder.
The ETACS ECU is attached to the back of the fuse box.
Tachometer white or BLACK/ white   ac   engine speed detection connector
Notes: The engine speed detection connector is a single pin connector in the fuse/relay box under the hood.
Can also go to one of the ignition coils or the distributor assembly and use the BLACK/ blue or WHITE/ green wire.
Wait to start N/A       
Brake Wire GREEN/ orange   +   brake pedal switch
Parking Brake YELLOW /GREEN   -   parking brake switch
Horn Trigger lt. GREEN/ black   -   pin 44 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Memory Seat 1 N/A       
Memory Seat 2 N/A       
Memory Seat 3 N/A       
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Transponder
Part #: 556UW
Alternate Part1 #: DesignTech 20402
Alternate Part2 #: DesignTech 29402
Notes: Standard on all models.
jraguilar 
Member - Posts: 3
Member spacespace
Joined: October 06, 2006
Location: United States
Posted: October 17, 2006 at 2:50 PM / IP Logged  
thanks for the help it is the 2004
jraguilar

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, March 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer