1999 Grand Am, Autostart starter

Home / the12volt's Install Bay / Car Security and Convenience / 1999 Grand Am, Autostart starter (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

gavin9797

Copper - Posts: 106

Joined: April 26, 2005

Location: Canada

Posted: October 25, 2006 at 10:27 PM / IP Logged

Hey everyone,

A friend at work is trying to install this remote starter, in said car. I dont know the model number on the starter I forgot to ask. He also has the 555L bypass.

After reading the searched forum he seams to be having the same problem as everyone else. The vehicle shuts down after startup.

Without knowing the starter model, any general suggestions for remedy?

Thank you.

Back to Top

Hymer

Silver - Posts: 695

Joined: November 20, 2004

Location: United States

Posted: October 25, 2006 at 11:38 PM / IP Logged

Fuel pump might not be fireing up.... grey in the drivers kick. pulses 1 sec before crank, stops during crank, then goes hot after startup....

Tire Proz Stillwater Mn

High End Restyling and Comlete Repair

Back to Top

green6767

Copper - Posts: 209

Joined: October 28, 2005

Location: United States

Posted: October 26, 2006 at 8:28 AM / IP Logged

Sounds like a passlock II issue. When that isn't bypassed correctly, it will shutdown right after startup when remote started. I assume the car starts fine with the key? Does it remote start with the key in the ignition?

Shaun, we are the same height, that is neat!

12V Installation Technician for Honda, Dodge, Chrysler, Toyota and Jeep.

Back to Top

Velocity Motors

Moderator - Posts: 12,488

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Fabrication. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: October 26, 2006 at 11:01 AM / IP Logged

Make sure that the status output wire/ground when running wire is sending a (-) signal to the 555L and also make sure that the 555L is hooked up properly and learned the R-Code properly as well.

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Back to Top

Search for other posts by Velocity Motors

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

1999 Grand Am, Autostart starter

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.