2006 Monte Carlo

Need wiring info for this vehicle. It has keyless entry and remote start, I would like to install an aftermarket alarm and interface it with the factory remote start. Any help is appreciated. Thanks.

DIRECTWIRE™ WIRING INFORMATION - CHEVROLET / MONTE CARLO / 2006 / Remote Start [PRINT THIS PAGE] 12volts      RED / white (10A)       +       ign harn or BCM, blue plug, pin 3 Notes: The BCM (Body Control Module) is to the left of the steering column. Starter      yellow (not for remote start)       +       ECM Notes: On the V6 models, the starter wire is in the blue plug, pin 26. On the V8 models, the starter wire is in the black plug, pin 22. The ECM (Engine Control Module) is behind the driver side headlight, in the air cleaner assembly. There is a white wire and a WHITE/ black wire in the ignition harness, or the BCM, green plug, pins 2 and 4, that perform starter, second ignition, and key sense functions. No information at this time, if it is necessary to interface with these wires in addition to the PASS-key III+. Second Starter      N/A             Ignition      pink       +       ign harn or BCM, green plug, pin 14 Notes: The BCM (Body Control Module) is to the left of the steering column. Second Ignition      see starter wire notes             Third Ignition      N/A             Accessory      brown       +       ign harn or BCM, green plug, pin 21 Notes: The BCM (Body Control Module) is to the left of the steering column. Second Accessory      N/A             Keysense      see starter wire notes             Power Lock      ORANGE / black       -       driver kick or BCM, gry plug, pin 12 Notes: The BCM (Body Control Module) is to the left of the steering column. Power Unlock      ORANGE / black       -       driver kick or BCM, gry plug, pin 11 Notes: The BCM (Body Control Module) is to the left of the steering column. Lock Motor      gray       5wi      DKP or fuse box, 40 pin plug, pin J2 Notes: The fuse box is on the passenger side, end of the dash. Unlock Motor      tan       5wi      DKP or fuse box, 40 pin plug, pin J3 Notes: The fuse box is on the passenger side, end of the dash. Parking Lights+      purple (L), BROWN / white (R)       +       passenger kick, harness to rear Parking Lights-      BROWN / white       -       switch or BCM, white plug, pin 8 Notes: The BCM (Body Control Module) is to the left of the steering column. Hazards      tan       -       switch or BCM, green plug, pin 19 Notes: The BCM (Body Control Module) is to the left of the steering column. Turn Signal(L)      lt. blue/white (F), yellow (R)      +       BCM, brn plg, pin 4; brn plg, pin 1 Notes: The BCM (Body Control Module) is to the left of the steering column. Turn Signal(R)      dk. blu/wht (F), dk. green (R)      +       BCM, blk plg, pin 5; brn plg, pin 2 Notes: The BCM (Body Control Module) is to the left of the steering column. Reverse Light      lt. green       +       pass kick or BCM, pink plug, pin 2 Notes: The BCM (Body Control Module) is to the left of the steering column. Door Trigger      gray/black (D), tan/white (P)       -       ea kick or BCM, pnk plug, pins 10, 8 Notes: Use both wires and diode isolate each. The BCM (Body Control Module) is to the left of the steering column. Dome Supervision      gray/black       +       driver kick or BCM, pink plug, pin 1 Notes: The BCM (Body Control Module) is to the left of the steering column. Trunk/Hatch Pin      ORANGE / black       -       pin switch or BCM, pink plug, pin 12 Notes: The BCM (Body Control Module) is to the left of the steering column. Hood Pin      pink/black       -       pin switch or BCM, blk plug, pin 17 Notes: The BCM (Body Control Module) is to the left of the steering column. Trunk/Hatch Release      lt. blue       -       switch or BCM, white plug, pin 10 Notes: The BCM (Body Control Module) is to the left of the steering column. The trunk release motor wire is tan/white (+) at the fuse box, 40 pin plug, pin A5. The fuse box is on the passenger side, end of the dash. Power Sliding Door      N/A             Factory Alarm Arm      factory remote only             Factory Alarm Disarm      factory remote only             Disarm No Unlock      with ignition and Passkey             Tachometer      NOT pink/black       ac       any fuel injector Wait to start      N/A             Brake Wire      lt. blue       +       kick panel or BCM, brown plug, pin 5 Notes: The BCM (Body Control Module) is to the left of the steering column. Parking Brake      ORANGE / black       -       switch or BCM, pink plug, pin 22 Notes: The BCM (Body Control Module) is to the left of the steering column. Horn Trigger      tan       -       switch or BCM, brown plug, pin 18 Notes: The BCM (Body Control Module) is to the left of the steering column. Memory Seat 1      N/A             Memory Seat 2      N/A             Memory Seat 3      N/A             Interface Module:      Category: Immobilizer Bypass      Required: Yes      Type: PASS-Key III+ Part #: 556UW Alternate Part1 #: DesignTech 20402 Alternate Part2 #: DesignTech 29402 Notes: Standard on all models. Smart Starter Kill Relays:      Relay Type: Starter Relay      Location: Engine compartment fusebox, Passenger side Part #: 6402A Notes: If equipped with factory remote start, SSKR not recommended warning       This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. gcorrea

Thanks for the reply, sorry for the delay. I don't get out much.

yeah i dont know how you would interface it with the factory remote start.......astrostart puts out a factory remote start range extension control module but i dont think it works with every gm vehicle.....you may be better off just installing a remote start/alarm combo unit....but i dont think that there is any kind of remote start activation input for your factory starter that uses an analogue signal.