another way, undercar neons?

Home / the12volt's Install Bay / Lights, Neon, LEDs, HIDs / another way, undercar neons? (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

aznrico

Member - Posts: 1

Joined: November 29, 2006

Location: Canada

Posted: November 29, 2006 at 12:30 PM / IP Logged

I recently bought an undercar neon kit and looked at the instructions. I was debating if I should actually install them or not, since I found out that the only way to mount them involves drilling holes. I am worried about the car rusting because of this installation method; can anyone suggest another way to mount these tubes without drilling? or to prevent rust under the car? I haven’t been successful in looking for other kits without screws.

Back to Top

ill-logix

Member - Posts: 39

Joined: April 07, 2006

Location: United States

Posted: November 29, 2006 at 1:29 PM / IP Logged

You can paint the hole with either an epoxy based spray paint Or use a galvanising zinc spray paint. You can find the

Back to Top

ill-logix

Member - Posts: 39

Joined: April 07, 2006

Location: United States

Posted: November 29, 2006 at 1:32 PM / IP Logged

Sorry, bumped the send button.

You can find the zinc spray at a place that carries welding supplies. You could also try ospho.

Back to Top

bballguy162006

Member - Posts: 21

Joined: November 17, 2006

Location: United States

Posted: December 06, 2006 at 3:27 PM / IP Logged

Mabye you could use JB Weld? Although that would be permanent...

Back to Top

Search for other posts by bballguy162006

myzery

Member - Posts: 4

Joined: February 27, 2006

Location: United States

Posted: December 22, 2006 at 6:09 PM / IP Logged

You can also try...

After you've mounted the tubes to the underside of the car, tape off the tube where there is a screw near, and hit the area with some Rubberized Undercoating. It'll keep out moisture and prevent rust in the holes. And when you remove them, hose the holes again till they're completely covered.

Back to Top

justified07

Member - Posts: 2

Joined: January 03, 2007

Location: United States

Posted: January 03, 2007 at 2:13 AM / IP Logged

When you install the neons with the screws put some silicon on the screw before you put it to the undercar body so that when the screw goes in the metal its also got a sealent on the screw, you can get silicon at any parts store just ask for silicon glue it comes in a tube like what your toothpaste comes in, hope that helps.

Back to Top

jmendez452

Member - Posts: 5

Joined: January 08, 2007

Location: United States

Posted: January 09, 2007 at 11:29 PM / IP Logged

use wire tie rods

j mendez

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

another way, undercar neons?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.