reverse lights, headlights to turn on

you can use the dome supervision wire for that if that unit does not have an illuminated entry wire. Make sure you diode isolate it from the dome light too or else your headlights will turn on with the dome light. Hook the dome supervision wire to 85, fused 12 volts to 86 and 30, and then 87 is your high current positive output (if you tapped into a strong 12 volt source). You can hook this output to the reverse lights and the headlights, but you must either use another relay, or some high current diodes to isolate them from each other. To do it with another relay just wire another one up the exact same way. good luck!Seth Alvo     NY

Mobile Electronics Installer

makes sense thanx im a try that.----ish----

i hate relays!!!!!!!!!!!!!