2006 Dodge Ram Alarm/Remote Start/Stereo Wiring

DODGE / RAM PICKUP / 2006 / Remote Start 12volts               lt. blue/red (2A)       +       ignition harness Starter               dk. GREEN/ YELLOW       +       ign harn or starter       button (SRT-10) Second Starter        PURPLE / brown       -       ignition harness Notes: The second starter wire is negative trigger thru an 180 ohm resistor. MUST use a relay. Refer to DirectFax document 1084 for wiring information. Ignition      pink/white              +       ignition harness             Accessory      same as second starter wire       -       ignition harness Notes: The accessory wire is negative trigger thru a 610 ohm resistor. MUST use a relay. Refer to DirectFax document 1084 for wiring information.             Power Lock      PURPLE / dk. green       -       DKP or cluster, sml gry plug, pin 3 Notes: Lock is negative trigger thru an 820 ohm resistor. Unlock is negative trigger thru a 330 ohm resistor. MUST use relays. Can also use Directed interface module. Power Unlock      same as power lock wire             Lock Motor      lt. green       5wi      DKP or cluster, white plug, pin 10 Unlock Motor      tan/lt. green       5wi      DKP or cluster, white plug, pin 1 Parking Lights+      WHITE/ yel (L), WHITE/ gray (R)       +       harness at top of driver fender Parking Lights-      WHITE/ lt. green       -       sw or cluster, sml gry plug, pin 5 Notes: Parking lights are negative trigger thru a 1130 ohm resistor. MUST use a relay. Hazards      WHITE/ orange       -       sw or cluster, sml gry plug, pin 8 Notes: Hazards are negative trigger thru a 120 ohm resistor. MUST use a relay. Turn Signal(L)      wht/lt grn (F), wht/dk grn (R)      +       harness at top of driver fender Turn Signal(R)      WHITE/ tan (F), WHITE/ yel (R)       +       harness at top of driver fender Reverse Light      WHITE/ lt. green       +       harness at top of driver fender Door Trigger      see notes       -       each kick or cluster, lrg gray plug Notes: The LF door is purple in pin 1. The RF door is PURPLE / white in pin 4. The LR door is PURPLE / orange or PURPLE / gray in pin 2. The RR door is purple / YELLOW or tan / YELLOW in pin 3. Use all four wires and diode isolate each wire from each other and the instrument cluster. See DirectFax document 1076 for wiring information. Dome Supervision      yellow/lt. blue       +       A pillar or cluster, wht plg, pin 21                   Factory Alarm Arm      factory remote only             Factory Alarm Disarm      factory remote only             Disarm No Unlock      with ignition and Sentry Key             Tachometer      dk. blue/gray       ac       PCM, BLACK/ orange plug, pin 34 Notes: The PCM is on the passenger side firewall. The BLACK/ orange plug is the second plug down from the top. On SRT-10 models, the tach wire is in the top black plug, pin 18. On diesel models, the tach wire is at the ECM on the lower driver side of the engine, front 60 pin plug, pin 24, or at the camshaft position sensor just left of the ECM, in a 3 pin plug. On gas models, can also go to any ignition coil or fuel injector and use the wire that is NOT BROWN / white. Wait to start      see DirectFax document 1091             Notes: On the remote start, make sure to program the Accessory State During Wait To Start to ON. Brake Wire      WHITE/ tan       +       brake pedal switch Parking Brake      dk. GREEN / WHITE       -       sw or cluster, lrg gry plug, pin 22 Horn Trigger      dk. GREEN/ purple       -       sw or cluster, lrg gry plug, pin 14             Interface Module:    Category: Immobilizer Bypass          Required: Yes    Type: Sentry Key        Part #: 556UW        Alternate Part1 #: DesignTech 20402        Alternate Part2 #: DesignTech 29402             Notes: Standard on all models except the ST. Interface Module:    Category: Door Lock Interface    Required: No    Type: Multiplex        Part #: 456LW Interface Module:    Category: Combo Interface    Required: No    Type: Data Bus        Part #: IOM-Chrysler-7 Notes: When using the IOM-Chrysler-7 it is not necessary to   use doc 1084. That part takes care of 2nd starter and accessory, locks, and bypass. warning       This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.

Radio 12v      gray/red                +     radio harness Radio Ground      black and BLACK/ lt. green -       radio harness       Radio Ignition      (CAN data bus)                   Radio Illumination      N/A                   Factory Amp Turn-on      N/A                   Power Antenna      N/A                   LF Speaker +/-      dk. grn/yel - dk. grn/lt. blue      +,-      radio harness or amp behind glovebox      RF Speaker +/-      gray / YELLOW - gray/lt. blue       +,-      radio harness or amp behind glovebox      LR Speaker +/-      gray/lt. grn - gray/dk. grn       +,-      radio harness or amp behind glovebox      RR Speaker +/-      dk. grn/lt. grn - dk. grn/gray      +,-      radio harness or amp behind glovebox