the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2007 suburban, alarm wiring


Post ReplyPost New Topic
< Prev Topic Next Topic >
arlanandglenda 
Member - Posts: 1
Member spacespace
Joined: January 24, 2007
Posted: March 11, 2007 at 12:12 AM / IP Logged  
I am installing a car alarm for a 2007 Suburban. I looked in the wiring database and there wasn't one for a 2007 Suburan. Can anyone help by providing wiring schematics? Thanks.
KarTuneMan 
Platinum - Posts: 7,056
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member consistently provides reliable informationspace
Joined: December 14, 2004
Location: Isle Of Man
Posted: March 11, 2007 at 12:27 PM / IP Logged  
PASSIVE ANTI-THEFT YES TRANSPONDER   SEE NOTES 
 This vehicle is equipped with a TRANSPONDER passive anti-theft system. A bypass module may be available which will not require a key. Contact your supplier to find out. If one is not available to you, please see the appropriate security diagram before any remote start installation.
 12 VOLTS RED / black In black plug on fusebox under dash   + 
 IGNITION Pink Ignition switch harness   + 
 ACCESSORY Brown Ignition switch harness   + 
 STARTER White Ignition switch harness   + 
 Start wire requires (+) through a 1280 ohm resistor.
 KEY SENSE Pink Ignition switch harness   + 
 TACH SIGNAL SEE NOTE     
 Go to any coil on the side of the engine and use the wire that is not Pink, Black or Brown.
 FUEL INJECTOR Opposite from Pink At any injector on engine   AC 
 LOCK Data module required     
 UNLOCK Data module required     
 DOORPIN Gray At BCM on the left side of the steering column   + 
 Located in the TAN connector.
 TRUNK PIN Pink/black At BCM on the left side of the steering column   - 
 Located in the PINK connector.
 TRUNK RELEASE Gray At BCM on the left side of the steering column   - 
 Located in the PINK connector. The glass release wire is PINK and is found in the same connector.
 FACTORY ARM Data module required     
 FACTORY DISARM Data module required     
 The OEM alarm will disarm automatically on remote start.
 BRAKESWITCH Blue/white At switch or BCM on left of steering column   + 
 Located in the BROWN connector.
 PARKLIGHTS (-) Lt.blue At light switch or BCM on left of steering column   - 
 Located in the TAN connector.
 HAND BRAKE Lt.blue At BCM on left of steering column   - 
 Located in the BROWN connector.
 HORN Tan At steering column or BCM   - 
 Located in the BROWN connector. The BCM is located on the left side of the steering column.
 VSS WIRE Yellow/black In Black connector on ECM   AC 
 The ECM is located on the driver's side of the engine compartment behind the headlight.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Sunday, April 21, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer