2002 accord compustar cm3000 remote start

Home / the12volt's Install Bay / Car Security and Convenience / 2002 accord compustar cm3000 remote start (

Topic Closed)

Welcome Guest :)

Members

Next Page > < Prev Topic Next Topic >

proatthagame

Copper - Posts: 65

Joined: April 16, 2006

Location: United States

Posted: March 28, 2007 at 7:07 PM / IP Logged

Need some help please.

My remote start cranks and turns over. It sounds fine. Then...it will crank one more time.....and the enigine will continue to run but it will sound like crap. I really would appreciate some help or advice on this. I have the tach hooked up properly (even tried it on a fuel injector wire, didnt work) and i have relearned the tach several times.

Please Help.

Yours Truly

KarTuneMan

Platinum - Posts: 7,056

This member has made a donation to the12volt.com. Click here for more info.

This member consistently provides reliable information

Joined: December 14, 2004

Location: Isle Of Man

Posted: March 28, 2007 at 10:24 PM / IP Logged

What do you mean....sound like crap.?

Velocity Motors

Moderator - Posts: 12,488

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Fabrication. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: March 29, 2007 at 8:31 AM / IP Logged

Do you have the pin switch to TACH ? If you do, then go back to the place you bought it from and get the CPU replaced. The Compustar units have a lifetime warranty as long as you had it installed and purchased at a Compustar dealer.

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Search for other posts by Velocity Motors

proatthagame

Copper - Posts: 65

Joined: April 16, 2006

Location: United States

Posted: March 29, 2007 at 10:21 AM / IP Logged

KarTuneMan wrote:

What do you mean....sound like crap.?

It sounds fine when it initially cranks and starts then it will crank again and i will kinda hear a rattling noise and its a noise like the enigine is running real rough.

Unfortunalty Velocity, I bought it on ebay and put it in myself. It does have the tach switch.

Would it help if i tried to learn the tach with the engine warm or cold? Should i turn on all my accesories? (air, radio, etc..)

Yours Truly

dswift

Copper - Posts: 396

Joined: March 12, 2007

Location: United States

Posted: March 29, 2007 at 6:28 PM / IP Logged

If you went to the injector make sure you pluged the injector all the way in.

Does it start up rough with the key? if your tach was bad you would grind the starter. so if it runs your tach is fine.

"dont ground out!"

proatthagame

Copper - Posts: 65

Joined: April 16, 2006

Location: United States

Posted: March 30, 2007 at 12:21 PM / IP Logged

dswift wrote:

If you went to the injector make sure you pluged the injector all the way in.

Does it start up rough with the key? if your tach was bad you would grind the starter. so if it runs your tach is fine.

I never unplugged the injector. Just spliced into the wire. '

It doenst start rough with the key. It initailly remote starts up fine. After about 5 sec of running it will attempt to crank just ONE more time then it will run and not continue to crank but it will sound really bad.

Yours Truly

xtremej

Gold - Posts: 1,440

Joined: February 24, 2006

Location: United States

Posted: March 30, 2007 at 12:39 PM / IP Logged

Is it blinking the lights 1 time when you depress the tach button for tach learn? Just to confirm you have the brain switched to tach adn not alternator sensing?

proatthagame

Copper - Posts: 65

Joined: April 16, 2006

Location: United States

Posted: March 30, 2007 at 6:56 PM / IP Logged

xtremej wrote:

Is it blinking the lights 1 time when you depress the tach button for tach learn? Just to confirm you have the brain switched to tach adn not alternator sensing?

Yes they blink once.

Yours Truly

xtremej

Gold - Posts: 1,440

Joined: February 24, 2006

Location: United States

Posted: March 31, 2007 at 9:02 AM / IP Logged

Try this switch it to alternator sensing and hook it up to the stator wire off the alterantor. For somereason it is not sensing theat it is running I believe this is why it trying to start after its running. If this doesn't work I would try to get a new brain.

proatthagame

Copper - Posts: 65

Joined: April 16, 2006

Location: United States

Posted: April 01, 2007 at 12:54 AM / IP Logged

xtremej wrote:

Which wire is that on the alternator? Im going to try that and see what happens.

Yours Truly

Next Page >

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.