the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2005 add on alarm

Home / the12volt's Install Bay / Car Security and Convenience / 2005 add on alarm (Topic Closed Topic Closed)
Welcome Guest :)

Post ReplyPost New Topic
< Prev Topic Next Topic >
dennis rider 
Member - Posts: 10
Member spacespace
Joined: June 08, 2007
Location: United States
Posted: June 08, 2007 at 9:18 AM / IP Logged  

hello everyone,

i am in need of a wiring chart for a 2005 dodge dakota ,i am trying to install a crimestopper keyless entry and alarm ...trying to find out which wires i need to tap into...

thanks

pvd41

pvd41
rudydapimp 
Copper - Posts: 390
Copper spacespace
Joined: February 27, 2006
Location: United States
Posted: June 08, 2007 at 11:48 AM / IP Logged  
12voltsred, RED / lt. blue, RED / orange + ignition harness
Starterpink/lt. blue + ignition harness
Second StarterN/A
Ignitionpink/lt. green + ignition harness
Second Ignitionpink + ignition harness
Third IgnitionN/A
Accessorydk. blue and pink/white + ignition harness
Second Accessorypink / YELLOW (x2) + ignition harness
KeysensePURPLE / tan - ignition harness
Power LockPURPLE / dk. green - DKP or cluster, gry 16P plug, pin 3
Notes: Lock is negative trigger thru a 330 ohm resistor. Unlock is negative trigger thru a 100 ohm resistor. MUST use relays.
Power Unlocksame as power lock wire
Lock Motorlt. green 5wi DKP or cluster, gry 26P plug, pin 15
Unlock Motortan/lt. green 5wi DKP or cluster, gry 26P plug, pin 12
Parking Lights+pink/red (L), WHITE/ orange (R) + IPM, 20 pin plug, pins 15 and 17
Notes: The IPM (Integrated Power Module) is the fuse/relay box on the driver side fender.
The rear taillight wires run from this location down into a harness that follows the frame rail to the rear of the vehicle.
Parking Lights-pink/red - sw. or cluster, gry 16P plug, pin 5
Notes: Parking lights are negative trigger thru a 1130 ohm resistor. MUST use a relay.
HazardsWHITE/ orange - sw. or cluster, gry 16P plug, pin 8
Notes: The hazard lights are negative trigger thru a 120 ohm resistor. MUST use a relay.
Turn Signal(L)wht/lt. grn(F), wht/dk. grn(R) + FCM, 12 pin plg and IPM, 40 pin plg
Notes: The FCM (Front Control Module) is attached to the IPM (Integrated Power Module), which is the fuse/relay box on the driver side fender.
The rear taillight wires run from this location down into a harness that follows the frame rail to the rear of the vehicle.
Turn Signal(R)WHITE/ tan (F), WHITE/ orange(R) + FCM, 12 pin plg and IPM, 40 pin plg
Notes: The FCM (Front Control Module) is attached to the IPM (Integrated Power Module), which is the fuse/relay box on the driver side fender.
The rear taillight wires run from this location down into a harness that follows the frame rail to the rear of the vehicle.
Reverse LightWHITE/ lt. green + IPM, 40 pin plug, pin 27
Notes: The IPM (Integrated Power Module) is the fuse/relay box on the driver side fender.
The rear taillight wires run from this location down into a harness that follows the frame rail to the rear of the vehicle.
Door Triggersee notes - each kick or cluster
Notes: The LF door is purple in the gray 26 pin plug, pin 6. The RF door is PURPLE / white in the white plug, pin 23. The LR door is PURPLE / gray in the gray 26 pin plug, pin 8. The RR door is purple / YELLOW in the white plug, pin 22. Use all four wires and diode isolate each.
Dome Supervisionyellow/orange + cluster, white plug, pin 11
Notes: Also found in the passenger A pillar.
Trunk/Hatch PinN/A
Hood PinN/A
Trunk/Hatch ReleaseN/A
Power Sliding DoorN/A
Factory Alarm Armarms on lock with door open
Factory Alarm Disarmfactory remote only
Disarm No Unlockwith ignition and Sentry Key
TachometerNOT red ac any ignition coil or fuel injector
Wait to startN/A
Brake WireWHITE/ lt. blue + brake pedal switch
Parking Brakedk. GREEN / WHITE - sw. or cluster, gry 26P plug, pin 3
Horn Triggerdk. GREEN/ purple - sw. or cluster, gry 26P plug, pin 10
Memory Seat 1N/A
Memory Seat 2N/A
Memory Seat 3N/A
2005 add on alarm -- posted image.
Interface Module:Category:
Combo Interface 		Required:
No		Type:
Data Bus
Part #: IOM-Chrysler-7
Notes: When using the IOM-Chrysler-7 it is not necessary to use doc 1084. That part takes care of 2nd starter and accessory, locks, and bypass.
Interface Module:Category:
Immobilizer Bypass 		Required:
Yes		Type:
Sentry Key
Part #: 556CW
Alternate Part1 #: 556UW
Alternate Part2 #: DesignTech 20402
Alternate Part3 #: DesignTech 29402
KarTuneMan 
Platinum - Posts: 7,056
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member consistently provides reliable informationspace
Joined: December 14, 2004
Location: Isle Of Man
Posted: June 08, 2007 at 11:48 AM / IP Logged  
12 VOLTS RED / Orange & RED / blue Ignition harness   + 
IGNITION Pink/green Ignition harness   + 
LOCK Violet/green SEE NOTES   - 
 Use a ground pulse through a 110-ohm resistor to unlock a ground pulse through a 300-ohm resistor to lock the doors. On fully equipped versions with memory seats, these wires will be located inside the driver's door. Without memory seats, this wire is found on a white plug near the fusebox.
 UNLOCK Violet/green SEE NOTES   - 
 Use a ground pulse through a 110-ohm resistor to unlock a ground pulse through a 300-ohm resistor to lock the doors. On fully equipped versions with memory seats, these wires will be located inside the driver's door. Without memory seats, this wire is found on a white plug near the fusebox.
DOORPIN SEE NOTES     
 Doorpins are independent. Driver's door is Violet, passenger door is Violet/White, left rear door is Violet/Gray, right rear door is Violet / YELLOW. All wires are negative (-) and can be found iin their respective kickpanels or behind the instrument cluster.
 FACTORY ARM Arms with lock wire     
 FACTORY DISARM Through OEM remote only     
PARKLIGHTS SEE NOTES     
 Use WHITE/ orange and Pink/red on the black connector at the fusebox (isolate with 2 relays). Or you can run a wire to pin #85 at the parking light relay under the hood. Turn on lightswitch and listen for clicking to find relay.
dennis rider 
Member - Posts: 10
Member spacespace
Joined: June 08, 2007
Location: United States
Posted: June 10, 2007 at 8:58 PM / IP Logged  

good evening,

i have a dodge dakota 2005 slt...this has keyless entry only...no keysense or alarm...i want to install a crimestopper model 2002DC-IV...i am in need of the wiring for the power door lock/unlock and flashing parking lights at arm/disarm...also the door trigger wire...

any help would be great

many thanks

pvd41

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Saturday, October 25, 2025 • Copyright © 1999-2025 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer