05 Chrysler PT Cruiser Convertible Alarm/Remote Start Wiring
Welcome Guest :)
guinness2
Member -
Posts: 3
Joined: May 29, 2002
Location: United States
Posted: June 27, 2007 at 2:11 PM / IP Logged
Can anyone help me with a complete security,remote start wiring diagram for this car?
KarTuneMan
Platinum -
Posts: 7,056
Joined: December 14, 2004
Location: Isle Of Man
Posted: June 27, 2007 at 2:58 PM / IP Logged
| PASSIVE ANTI-THEFT | YES | TRANSPONDER | SEE NOTES |
| 12 VOLTS | Pink/black | Ignition switch harness | + |
| IGNITION | Blue | Ignition switch harness | + |
| ACCESSORY | BLACK/ orange | Ignition switch harness | + |
| STARTER | Yellow | Ignition switch harness | + |
| KEY SENSE | Lt.blue | Ignition harness | - |
| TACH SIGNAL | BLACK/ gray | At PCM under hood | AC |
| | | The PCM is located on the driver's side firewall under the hood. The BLACK/ GRAY is found in the gray connector. |
|
| LOCK | WHITE/ green | Above driver's kickpanel | - |
| | | This vehicle uses multiplexing where a single wire performs all lock and security functions, resistors are required. See the DOORLOCKS diagram for wiring details. |
|
| UNLOCK | WHITE/ green | Above driver's kickpanel | - |
| | | This vehicle uses multiplexing where a single wire performs all lock and security functions, resistors are required. See the DOORLOCKS diagram for wiring details. |
|
| DOORPIN | SEE NOTES | White connector in driver's kickpanel | - |
| | | TAN (driver's door), BLUE/ORANGE or BLUE (all other doors). Both wires are found in a WHITE connector in the driver's kickpanel. |
|
| TRUNK PIN | Tan/black | White connector in driver's kickpanel | - |
| FACTORY ARM | WHITE/ green | Above driver's kickpanel | - |
| | | This vehicle uses multiplexing where a single wire performs all lock and security functions, resistors are required. See the DOORLOCKS diagram for wiring details. |
|
| FACTORY DISARM | WHITE/ green | Above driver's kickpanel | - |
| | | This vehicle uses multiplexing where a single wire performs all lock and security functions, resistors are required. See the DOORLOCKS diagram for wiring details. |
|
| BRAKESWITCH | WHITE/ tan | In driver's kickpanel | + |
| | | It is recommended that you use the wire found in the driver's kickpanel and not the one at the brakeswitch itself. |
|
| PARKLIGHTS | BLACK / YELLOW | At steering column | + |
| HAND BRAKE | Gray/black | Front right side of shifter | - |
| HORN | BLACK/ red | At steering column | - |
guinness2
Member -
Posts: 3
Joined: May 29, 2002
Location: United States
Posted: June 28, 2007 at 6:44 PM / IP Logged
Thank you for your quick response .
Follow the12volt.com
Friday, September 13, 2024
• Copyright © 1999-2024 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
Topic Closed)
Members
Search
Register
Login
Printable version
