2002 jeep grand cherokee alarm

Well, the XK531 mode 5 gives two flashes which states it will roll up the windows. One little problem: with the ignition off, there is no power to the windows. Does anyone know of a way to keep the power active for the windows? I am not sure if the Jeep's computer can do that.Otherwise, I guess my options would be to use a relay and supply power via the Aux2 Output of the alarm system to provide power to the windowsAnyone have any other idea?

Oh, forgot to add..."extreme1" (who seems very knowledgeable) says it will require a 2nd lock pulse. I do not see this option in the manual for the Galaxy 5000RS-2W. Only 2nd unlock pulse. Is there any way to "simulate" this?

After you reprogram the XK531, just lock the doors twice in a row with the aftermarket remote.

Because it is configured into the OBDII you may be able to activate them with a Snap-on scan tool called a Modis. It alows us Techs to activate and control sensors and such with it but, I DON'T know if so.Move It! Or Loose It!

There is a timer relay to keep a stereo on for up to 30 seconds after ignition is off. I believe from DEI.Move It! Or Loose It!

the doors always have power going to them, because they are "modules" in each front door there is always power and the vehicles BCM tells them when to turn on and off, therefore you are able to do data rollup.Shaughn Murley

Install Manager, Dealer Services

Visions Electronics

Red Deer, Alberta

Chris Luongo said: After you reprogram the XK531, just lock the doors twice in a row with the aftermarket remote.Well, the Galaxy alarm has one button that arms and disarms the system. I even tried the factory RKE to lock the doors twice but that didn't work either.Yes, the doors have power but when the ignition is off, there is no power to the windows. I'll keep at it. There is an answer somewhere.Thanks.

maybe use an aux output and tie it into the lock wire, then you can lock, then hit the aux button as your second pulse.Shaughn Murley

Install Manager, Dealer Services

Visions Electronics

Red Deer, Alberta

Hello everyone,Here is the dilemma:One button locks and unlocks the doors and disarms the alarm.So, pressing the lock button doesn't send 2 locks commands, it will lock and then unlock.The XK531 module will roll up the windows with a double lock pulse.Does anyone know how to take the door lock output from the alarm and turn it until a double ground pulse? This way the doors will lock and the 2nd lock pulse will roll up the windows.As of right now, I am using the Aux1 output and pressing it after the doors lock. It is a viable work-around but would like a one-button approach.The alarm is a Galaxy 5000RW-2W and the door lock/transponder override is the XK-531.Any suggestion is appreciated.Thanks,

BTW, Extreme1's suggestion does work. But, still looking for an "all-in-one" option. Thanks extreme1