mazda cx 7 pkf 3 not working

Home / the12volt's Install Bay / Car Security and Convenience / mazda cx 7 pkf 3 not working (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

rocan

Member - Posts: 6

Joined: September 23, 2007

Location: Newfoundland, Canada

Posted: October 11, 2007 at 7:12 PM / IP Logged

Yes, I checked all of them. I have been looking at other programming tips on this forum and one of them says that if the module LED is solid or flashing rapidly, reverse tx/rx wires.

When not in use, my pkf3 module is flashing like the dash security light (once/second), but when I am programming, it flashes rapidly (3 times/second) when the key is turned to "on". Is supposed to do that, or is it supposed to be solid when programming?

Back to Top

moonliter

Copper - Posts: 322

Joined: February 28, 2007

Location: Canada

Posted: October 11, 2007 at 7:50 PM / IP Logged

rocan wrote:

Yes, I checked all of them. I have been looking at other programming tips on this forum and one of them says that if the module LED is solid or flashing rapidly, reverse tx/rx wires.

When not in use, my pkf3 module is flashing like the dash security light (once/second), but when I am programming, it flashes rapidly (3 times/second) when the key is turned to "on". Is supposed to do that, or is it supposed to be solid when programming?

go ask bypasskit http://www.bypasskit.com/kbnet/ask.aspx

Back to Top

extreme1

Silver - Posts: 1,070

Joined: February 12, 2003

Location: Canada

Posted: October 11, 2007 at 9:47 PM / IP Logged

does your CX7 have the keyless start? are you taking the key inserts out of the cards and hiding the cards away from the vehicle (I find inside a toolbox works best)?

Shaughn Murley

Install Manager, Dealer Services

Visions Electronics

Red Deer, Alberta

Back to Top

rocan

Member - Posts: 6

Joined: September 23, 2007

Location: Newfoundland, Canada

Posted: October 12, 2007 at 5:45 AM / IP Logged

No, not keyless. I have the flipstyle key.

Back to Top

howie ll

Pot Metal - Posts: 16,466

Joined: January 09, 2007

Location: United Kingdom

Posted: October 12, 2007 at 2:20 PM / IP Logged

I used the "remove the antenna ring and bury the key in it" method with one of these but I was installing a UK Cat I so I was putting 2 x cuts in anyway, I had far more trouble sorting out the locking system and finding the direction indicators, because it was all data at the front end.

Back to Top

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

mazda cx 7 pkf 3 not working

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.