single wire door lock, 2000 grand am

i have a 2000 pontiac grand am an have a clifford matrix 3.2 alarm/starter installed but my only problem i have is my single wire door lock system. i have tha relay info an have them wired up but when i turn my alarm on an off the doors dont lock or unlock an tha relays are in fine workin condition. Also i do have tha 1.5k resistor needed for tha unlock relay. heres tha relay break down LOCK RELAY 30-ground, 85-neg. lock output from alarm, 86-constant + 12v fused, 87-output to lock/unlock wire. UNLOCK RELAY 30-ground, 85- neg. unlock output from alarm, 86-constant + 12v fused, 87-1.5k resistor to lock/unlock wire. i have tha ground connected to tha chasis an tha + 12v fused tied into my alarm power wire. any help would be greatly appreciatedtk

Are you absolutely sure you are on the right wire in the vehicle? Your relay setup looks correct. The tech sheet also says that your door must be shut for the vehicle to lock with a single pulse.Installer, IT support, and FFL. I need less hobbies.

yea i used my meter to double check tha door lock/unloc wiretk

I have a 10 pin connector in drivers kick, its a white wire at the end, across from it in the next row is a light GREEN/ black..I also have a 500 ohm to unlock..try connecting the wire directly to ground if it meters out ok, it should at least lock, then you will know you have the right wire and not an alarm problem

ok problem solved it was my lock an unlock wires coming from tha alarm switched them wit another one from a different unit an it works now don't kno if they jus shorted out cuz cuz the're not jus 2 wires they have a box wit tha lock/unlock wires an a 12v constant fuse commin out of ittk