1996 riviera sc, remote start, vats bypass

1996 Buick Riviera SC

I just installed a Python 1400XP Remote starter,and purchased a Self learning Passlock Bypass,for Passlock 1 Passlock 2 and VATS. By Peripheral Electronics model # PPLJX They have since replaced this with model# PPLXR.

The remote starter works wit the key in the ignition,only in the ON position,however i can not get the bypass module to respond. It has power and the LED lights up. The VATS signal wires, White and white. but only 1 of the wires will allow me to connect to, the other disables the whole system altogether.

Wiring instructions Link:   http://peripheralelectronics.com/periph_products/Instructions/PPLXR.pdf

The only wires i connected were:

Brown: after programming.

Green: Key sense

Blue: VATS signal wire

Pink: Ignition

Red: 12v constant

because it says for VATS,and separates the others as Passlock 1 or 2 only.

Thanks for any help!

did u program it to vats its default setting is passlock 2  for ions need to go to step 1 to chane it to vats

then program your resistor code after you  have changed it .

since i have the older model PPLJX  it has a jumper setting to select between VATS and passlock.

I could not get the bypass module to work...so i just used basic resistors..but come to find out i didnt have enough power to power up the vats module,and computer..so i had to use the other 12v constant they supplied as a back up if needed,now everything works.