the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

crackling audio


Post ReplyPost New Topic
< Prev Topic Next Topic >
zsupra1221 
Member - Posts: 36
Member spacespace
Joined: November 25, 2007
Location: New Jersey, United States
Posted: November 27, 2007 at 11:39 AM / IP Logged  
Hey everyone,
I have a Valor multimedia head unit and when I play a DVD there is a loud crackling noise coming from my speakers, mainly from my passenger door speaker. This also happens when I use my Ipod, and not as much during a CD and the radio.I have two sets of component speakers in my doors, two 12 inch subs, and one 4 channel amp, and one sub mono amp. All the equipment is Alpine except my head unit. Is the crackling because of bad wiring? I think so. Should I buy a better wiring kit and rewire everything? Could this also be because of the wires being too close together? Or could this be because I have a Valor head unit with Alpine speakers, subs and amps. Also, there is a lot of white noise coming through the speakers when I turn them on with the amps.
Any suggestions and advice would be great.
Thanks a lot guys!
-ZSupra1221
zsupra1221 
Member - Posts: 36
Member spacespace
Joined: November 25, 2007
Location: New Jersey, United States
Posted: November 27, 2007 at 11:48 AM / IP Logged  
Also every time I push the gas pedal down, a high pitched noise comes into my car. My guess is that this is because of my alternator. I think what happens is that when I push down the pedal the battery gets drawn into my car through the alternator, thus every time I push down the pedal more and more a louder higher pitched noise comes into my car has the alternator turns faster. I think this noise is coming through my car speakers.
Any ideas on how to fix/stop/prevent this noise??
Thanks again!
-ZSupra1221
ibasspro 
Copper - Posts: 95
Copper spacespace
Joined: October 10, 2007
Location: California, United States
Posted: November 27, 2007 at 11:50 AM / IP Logged  

Valor may be a great priced unit (black Friday we had the 701 for $247), but it's outputs are very dirty. I am assuming you have the gain WAY up on the amps?.....hence the hiss. Pull the RCA out of the amp, & swap right & left, if the other speaker now crackles, you know it is rca or head unit, if the same speaker still crackles, it is amp, wires, or speaker/ x-over.

Def. set the gains again, as it sound like they are at full sensitivity.

used to be loud, used to be fast...now I am married LOL
ibasspro 
Copper - Posts: 95
Copper spacespace
Joined: October 10, 2007
Location: California, United States
Posted: November 27, 2007 at 11:59 AM / IP Logged  

you posted while I was writing my mine......

what you have is called alternator whine. MOST of the time it is caused by having a ground loop. meaning the ground potential at the amp grounds are different than the ground potential at the deck. This is commonly cause by using the factory wiring for the deck, or not having a good ground on the amps.

Check the ground at the amps, & make shure it is tight, & to bare metal (not a painted surface). IF that does not cure it, reground the head unit to the kick panel (like you would an alarm).

Also, remember to set the gains correctly.

used to be loud, used to be fast...now I am married LOL
zsupra1221 
Member - Posts: 36
Member spacespace
Joined: November 25, 2007
Location: New Jersey, United States
Posted: November 27, 2007 at 8:11 PM / IP Logged  
Thanks everyone for your help!
What are the gains and how do I set them?
Thanks,
ZSupra1221
zsupra1221 
Member - Posts: 36
Member spacespace
Joined: November 25, 2007
Location: New Jersey, United States
Posted: November 29, 2007 at 9:32 AM / IP Logged  
If I used a capacitor or a filter, would that make the high pitched noise go away?
jmelton86 
Gold - Posts: 1,228
Gold spacespace
Joined: February 07, 2007
Location: South Carolina, United States
Posted: November 29, 2007 at 7:14 PM / IP Logged  

The gains are the knobs on the amp that match (when set properly) the voltage level from the RCA's from the deck to the output level of the amp.

Turn them all the way down, noting where they were, and see if the noise is gone.

2013 Kia Rio -90a alternator
DDX470HD GTO14001 GTO1014D (x3)
Big3 in 1/0G
1/0G to GTO14001

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Saturday, April 27, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer