2007 hyundai elantra remote start

Im going to be doing a starter install on a 2007 Elantra on site at a customers house today and im looking for all the hints and tips on doing this car please. I will be using a key in the box type bypass and im a little stumped about this key sense hookup if someone can help me find the easiest way to do that. I will be doing door locks and the trunk also. Here's the wire diagram i'll be working off of. DEI Lists: DIRECTWIRE™ WIRING INFORMATION - HYUNDAI / ELANTRA / 2007 / Remote Start [PRINT THIS PAGE] 12volts      black (40A), red (30A)       +       ignition harness Starter      white       +       ignition harness Second Starter      N/A             Ignition      blue       +       ignition harness Second Ignition      N/A             Third Ignition      N/A             Accessory      pink       +       ignition harness Second Accessory      yellow       +       ignition harness Keysense      green       +       ign harn or BCM, wht 24P plug, pin 4 Notes: The BCM (Body Control Module) is in the center dash, behind the A/C controls. Power Lock      green       -       dr kick or BCM, wht 20P plug, pin 3 Notes: The BCM (Body Control Module) is in the center dash, behind the A/C controls. Power Unlock      yellow       -       dr kick or BCM, wht 20P plug, pin 11 Notes: The BCM (Body Control Module) is in the center dash, behind the A/C controls. Lock Motor      gray       5wi      driver kick, gry 39 pin plug, pin 38 Unlock Motor      yellow       5wi      driver kick, gry 39 pin plug, pin 30 Parking Lights+      yellow (L), BROWN / orange (R)       +       fuse box, 30 pin plug, pins 22 and 6 Parking Lights-      blue       -       switch or BCM, wht 20P plug, pin 4 Notes: The BCM (Body Control Module) is in the center dash, behind the A/C controls. Hazards      green       -       BCM, gray 24 pin plug, pin 9 Notes: The BCM (Body Control Module) is in the center dash, behind the A/C controls. Turn Signal(L)      yellow/orange       +       switch or fuse box, 30P plug, pin 26 Turn Signal(R)      blue       +       switch or fuse box, 30P plug, pin 11 Reverse Light      gray or brown       +       fuse box, 30 pin plug, pin 13 or 14 Door Trigger      yellow       -       dr kick or BCM, wht 24P plug, pin 22 Notes: The BCM (Body Control Module) is in the center dash, behind the A/C controls. Dome Supervision      yellow       -       dr kick or BCM, gry 24P plug, pin 1 Notes: The BCM (Body Control Module) is in the center dash, behind the A/C controls. Trunk/Hatch Pin      green to GREEN/ black       -       dr kick or BCM, wht 24P plug, pin 23 Notes: The BCM (Body Control Module) is in the center dash, behind the A/C controls. Hood Pin      green       -       pin sw or BCM, wht 24P plug, pin 24 Notes: The BCM (Body Control Module) is in the center dash, behind the A/C controls. Trunk/Hatch Release      white       -       dr kick or BCM, wht 20P plug, pin 13 Notes: The BCM (Body Control Module) is in the center dash, behind the A/C controls. The trunk release motor wire is orange (+) in the fuse box, 30 pin plug, pin 28. Power Sliding Door      N/A             Factory Alarm Arm      green       -       dr kick or BCM, wht 20P plug, pin 1 Notes: Meter this wire while turning the key in the driver door key cylinder. The BCM (Body Control Module) is in the center dash, behind the A/C controls. Factory Alarm Disarm      blue to yellow       -       dr kick or BCM, wht 20P plug, pin 2 Notes: Meter this wire while turning the key in the driver door key cylinder. The BCM (Body Control Module) is in the center dash, behind the A/C controls. Disarm No Unlock      with ign, acc, and key sense             Tachometer      blue or red       ac       pass kick, gray 39 pin plug, pin 5 Notes: Also found at the instrument cluster, white plug, pin 20. Can also go to any fuel injector and use the wire that is NOT white. Wait to start      N/A             Brake Wire      white to black       +       sw or dr kick, gray 39P plug, pin 34 Parking Brake      blue       -       sw or fuse box, 20 pin plug, pin 8 Horn Trigger      red or GREEN/ orange       -       switch or BCM, gry 24P plug, pin 8 Notes: The BCM (Body Control Module) is in the center dash, behind the A/C controls. Memory Seat 1      N/A             Memory Seat 2      N/A             Memory Seat 3      N/A             Interface Module:      Category: Immobilizer Bypass      Required: Yes      Type: Transponder Part #: 556UW Alternate Part1 #: DesignTech 20402 Alternate Part2 #: DesignTech 29402 Notes: Only Canadian models have the immobilizer system. Smart Starter Kill Relays: Not Available warning       This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. You would need to energize keysense, yes. If you look at the notes for disarm/no unlock it specifies that the factory alarm will disarm with keysense, ignition and accessory. You do not mention which system you are installing, but with the DEI systems I use there is a status output wire that you would use to power a relay to provide +12V to the vehicle's keysense wire during remote start. You may also be able to just use the second ignition output to power it if your vehicle does not require both accessories for remote start.2003 Chevy Avalanche,Eclipse CD7000,Morel Elate 5,Adire Extremis,Alpine PDX-4.150, 15" TC-3000, 2 Alpine PDX-1.1000, 470Amp HO Alt.

probably too late, but all you need to hook up on the bypass (assuming it's a 556u) is power, ground, and status. if for whatever reason the car shutdown when trying to do the key takeover then hookup keysense. very few cars ever do though

Yeah, i already did the install, everything went well until the brain fried..gota go back tomorrow :( For future if people look this thread up, don't try to go to the BCM, it's a bitch, get everything in the kick panel! And the key sense wire is an GREEN/ orange in the ign harness.2003 Chevy Avalanche,Eclipse CD7000,Morel Elate 5,Adire Extremis,Alpine PDX-4.150, 15" TC-3000, 2 Alpine PDX-1.1000, 470Amp HO Alt.

how u fry the brain?

It just shorted out for no reason, I have had two Autostart products do that in the past week, never installation error, each time a new unit was plugged in and worked flawlessly. However now I am having an issue, I picked up a key in the box type security bypass with the stick on ring antenna, but it will not work unless the ring is outside in front of the key cylinder, so im looking for a better type of bypass, is there any recommendations?? Also, where have you guys gotten the alarm disarm wires? I could not locate it.2003 Chevy Avalanche,Eclipse CD7000,Morel Elate 5,Adire Extremis,Alpine PDX-4.150, 15" TC-3000, 2 Alpine PDX-1.1000, 470Amp HO Alt.