06 commander accessory wire?

I am about to install a valet remote starter for a friend and I can not find any info on which wire to use for the Accessory (Heater Blower).

Also wondering where is the best place to hook up the parking light output (-).

Any help is greatly appreciated.

Use a CAN bypass module..... makes the job a tad bit easier.

The parking lights... abit more tricky. You need to get to the light relay under the hood. Its the relay that is closest to the fender in the fuse box. Solder a negative parking light output to the first pin on the relay. It's the pin that is closest to the little 10 amp fuse below the relay.

I thought I'd add this info to my post.... it was sent to me via PM:

The accessory wire is a multiplexed wire in that application. You would need to cut the wire and provide the proper resistance to it during accessory and a different resistance during crank. Here is Audiovox's information on that wire: