8040 problems

Home / the12volt's Install Bay / General Discussion / 8040 problems (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

ratnerjon

Member - Posts: 6

Joined: October 31, 2002

Location: United States

Posted: November 04, 2002 at 6:37 AM / IP Logged

i have an alpine 8040 that Jeff e-mailled me the wiring diagram for it. I`m putting it in a 1995 GMC sierra p\u.The alarm came out of one of my cars about 8 years ago. I just bought an owners manual and brand new 8440 remote.The programming instructions included with the remote doesn`t seem to be complete.It says to put code rom chip from remote into main unit ,then reconnect power to main unit, and notice silver button on circuit board. It ends there! It doesn`t say what to do next! Also I have the valet switch installed but I also have a black box with access to a switch inside it that i don`t know what it is for.It has an Alpine part number 8313. Also in the wiring circuits 22-alarm out(+), and 25- warning out(-) should go to where?Any help would be greatly appreciatted. Really, I`m probablly not as dumb as I sound.

jon ratner

Velocity Motors

Moderator - Posts: 12,488

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Fabrication. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: November 04, 2002 at 9:24 AM / IP Logged

After you insert the chip into the main unit, you press the button to learn the code to the chip and then you re-insert the chip back into the remote control. The 8313 I THINK is the electroni impact sensor. Does it have two rubber gromets on the front on it ?

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Search for other posts by Velocity Motors

ratnerjon

Member - Posts: 6

Joined: October 31, 2002

Location: United States

Posted: November 04, 2002 at 2:58 PM / IP Logged

I have an electronic imact sensor 8327. This box is approx. 3 in. tall, 3 in. deep, and 2 in. wide. It has a metal mounting bracket on the back and a switch inside accessible thru a rubber grommet on top.It has two fairly large red wires,one smaller orange wire and a black wire coming out of the bottom.Also what does circuits 22 and 25 connect to ? Thanks for all your help Jeff, you`re a GOD!!!

jon ratner

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

8040 problems

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.