prob with pwr window module and one touch

Hello I have a 95 Chevy Blazer 4dr. that I'm installing a Scytek 5000RS-2W and Smart Window Module (in 2 window up/down mode) in. I've gotten most of the install done (thanks to researching these message boards) and only have a few issues. My Blazer has the One-Touch down feature for the drivers door. The control module for the "Express Down" feature seems to be built in to the door switch on the drivers door. I've found the up and down wires for the LF motor (Blue and Brown), but when I cut them and put the module in between, neither the module or the window switch work anymore. The RF window works fine, but the drivers side one doesn't. If I reconnect the wires the original way, the window works fine, so I know it's not the fuse, window motor, or switch. Since the RF window works with the module and both door switches, I'm thinking it must be something with the "Express Down" feature. I've searched around but can't seem to find any info on a fix for this. Can anyone point me in the right direction? Thanks in advance.

You're right about the express down being internal to the driver's door switch, however that shouldn't interfere with switching. If it's a Scytek module you're using, I've used them on cars with auto-down and didn't have any problems. I would suggest you recheck your connections - if you can post the instructions for the window module on here also that might be helpful. It sounds to me like you may have reversed the connections. C Renner's Auto Electronix

My service is cheap, quick, and good - pick any two