Wiring paths to doors - Ram Quad 2003 ST

Home / the12volt's Install Bay / Car Security and Convenience / Wiring paths to doors - Ram Quad 2003 ST (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

dveith

Member - Posts: 2

Joined: April 13, 2003

Posted: April 13, 2003 at 7:37 PM / IP Logged

Hi, I'm in need of help. The Dodge Ram 1500 ST (4 door) comes with manual door locks. I have installed actuators in all four doors now, but I need some help on how to route the wires to the doors. How/what to remove from the dash to get access, how to get the wires to the door hinge conduit areas. etc.

Thanks, dave

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: April 13, 2003 at 9:18 PM / IP Logged

do you have rubber boots going from the doors to the post???

if you have speakers in the doors then you have the rubber boots.

just run your wires through the boots. use a stiff wire

(coathanger)to help you run wires through the boots and into the dash area.

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

dveith

Member - Posts: 2

Joined: April 13, 2003

Posted: April 13, 2003 at 10:12 PM / IP Logged

[QUOTE=draasch]do you have rubber boots going from the doors to the post???

QUOTE]

Thanks David. Yes I do. I actually think I can handle the "door end". I've been getting pretty familiar with the doors with all the time I have spent installing the actuators in the four doors. My need is more to get instructions specific to a 2003 Ram 1500 on how to open up the dash to get access to the 'dash side' of the rubber boots, and also where/how to run the wires from the dash to the rear doors. I checked Installdr.com but the instructions there are not for the current model apparently.

Thanks, dave

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: April 13, 2003 at 10:22 PM / IP Logged

remove the rubber boot from the "A" post. and use a small flashlight to see if the light goes through to the inside. if so then use a small clothes hanger and fish it through. it shouldnt be that hard. you have the hardest part done. that was mounting the motors.....

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Wiring paths to doors - Ram Quad 2003 ST

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.