power ign, acc wire, 03 dodge ram

Howdy all I have a Viper 5901 that i just got for my2003 Dodge Ram 1500 SLT non chipped key I was wondering by looking at the tech sheet I know I have to power 2 ignition wires and 2 accessories from the sheet for my remote star to work properly I know the colors on the truck but what do I use off my alarm? I know it has to be some of these(Wires available Below) also what is the flex relay IN/out do and should I use it. Thanks in advance for all your help let me know i you need any more infor from me Heavy gauge remote start, (H3) 10-pin connector H3/1 PINK (+) IGNITION 1 INPUT/OUTPUT H3/2 RED / WHITE (+) FUSED (30A) IGNITION 2 / FLEX RELAY INPUT 87 H3/3 ORANGE (+) ACCESSORY OUTPUT H3/4 VIOLET (+) STARTER OUTPUT (CAR SIDE OF THE STARTER KILL) H3/5 GREEN (+) STARTER INPUT (KEY SIDE OF THE STARTER KILL WIRE) H3/6 RED (+) FUSED (30A) IGNITION 1 INPUT H3/7 PINK/WHITE (+) IGNITION 2 / FLEX RELAY OUTPUT H3/8 PINK/BLACK (+) FLEX RELAY INPUT 87A key side (if required) of FLEX RELAY H3/9 RED / BLACK (+) FUSED (30A) ACCESSORY/STARTER INPUT H3/10 NC (no connection) NC ➢ Remote start input, 5-pin connector 1 BLACK/ WHITE (-) NEUTRAL SAFETY SWITCH INPUT 2 VIOLET/WHITE TACHOMETER INPUT WIRE 3 BROWN (+) BRAKE SHUTDOWN INPUT WIRE 4 GRAY N/O or N/C (-) HOOD PIN SWITCH INPUT 5 BLUE/WHITE (-) 200 mA 2ND STATUS/REAR DEFOGGER OUTPUT ➢ Remote start auxiliary output, 5-pin 1 PINK/WHITE (-) 200mA FLEX RELAY CONTROL OUTPUT 2 ORANGE (-) 200mA ACCESSORY OUTPUT 3 VIOLET (-) 200mA STARTER OUTPUT 4 PINK (-) 200mA IGNITION 1 OUTPUT 5 BLUE (-) 200mA STATUS OUTPUTThanks and Gig'em

J

Your Viper 5901 comes factory set for 2 IGN outputs via its flex relay.  You will need an additional SPDT 30 A

relay for the second ACC output your truck needs.

At H3, you will connect H3/1 to the trucks IGN1.

H3/2 connect to +12v constant power (for flex relay).H3/3 is ACC1 and goes to the trucks ACC1.H3/4 is Start1 output.H3/5 is Start1 input.H3/6 connect to +12v constant.H3/7 is IGN2 and goes to the trucks IGN2.H3/8 is not used.H3/9 connect to +12v constant.

On the Remote Start AUX output 5 pin connector you will use the Orange wire at pin 2 to control the

extra relay and provide ACC2.  Wire the SPDT 30A relay as follows.Pin 85 to R/S AUX 5 Pin connector, pin2, Orange wire.Pin 86 and Pin 87 to  +12v constant fused at 30 amps.Pin 30 goes to trucks ACC2 wire.Pin 87A is not used and should be cut and properly insulated.

There is a Viper 5901 install guide in the Downloads section of this site for additional info.

Soldering is fun!

thanks so much this help alotThanks and Gig'em

J