84 300ZX Information

I purchased the DELTA PRO 5005 FM 2 WAY LCD PAGER  REMOTE STARTER CAR ALARM i will be istalling on my 84 300zx turbo. Anyone have any helpful hints before i get started. Door locks, starter function, window module etc.

|       ITEM      |     WIRE COLOR     |POL|       WIRE LOCATION        |

Notes:

Looking over the wiring diagram i am not clear on the istruction:

 #8 Blue/Orange wire on alarm. It says to  connect to ground output when running. Which wire is this on the 300zx wiring harness.

#14 Orange connect to 30amp relay for starter disable. is this built into the alarm or will i need a seperate relay. which wire on the 300zx should this be connected to?

#Which wire do i use with the window module that came with the alarm? Aux2 ?

I am trying to figure out how to wire my actuator for the driver side door lock.

The alarm wires are Blue, Green, Red and the actuator has Green and Blue.

Asianwolf said the relay is built in that conrols this. What am i missing here.

How do i wire it up?

I have wired up my window module as the instructions indicate.

Drivers window goes up , but passnger side will not.

84 300zx turbo

Blue/White driver side down

Blue/Black driver side up

Blue / YELLOW pass side up

Blue/Red pass side down

Blue +12v

Black Ground

On my 84 300zx. Using delta pro 5005 setup.

My remote start worked fine, today it just cranks, the acc lights and such don't activate as they did  before.

Previously i would hit the remote start button, the radio antenna would go up and the radio lights would illuminate then the engine would crank.

Today the engine cranks but the accessories don't come on.

All fuses check fine. Using a test light at the connector going into the alarm all tests normal.

i think i have gotten a bad brain box. I still cannot get my shock sensor to work even after a replacment was sent to me.

Check the outputs of the remote start. Sounds like you have a poor connection on the acccessory output.

Describe how you have each wire of your shock sensor connected.

the12volt • Support the12volt.com

I have a delta pro 5005. Sucessfully wired remote start, it worked fine. Now it won't start the car.

Previously the antenna would power up and raise, the accessory items would come on and then the car would start up.

Now the antenna doesn't go up or the acc items come on at all. The engine turns over but it won't start i think it isn't powering up the fuel pump.

any help , this is on an 84 300zx turbo.

I have a delta pro 5005. when i first hooked up the remote start it worked fine. i had some trouble out of the alarm. i sent it back and it was check out and sent back to me. before sending it off for repair the car would crank but not start. the accessory items don't come on as they did previously. what could be the problem