2009 corolla door tigger wiring

I am trying to wire the door trigger wire, either green or violet,from a viper 3203 to a 2009 corolla. I have tried all the possible combinations in wiring either the green or violet wire to the wires in the 6pin connector (white, WHITE/ red) but still have no luck in getting the alarm to go off when i open the door. Any advice or walkthrough? I posted this question in a another website forum two years ago, which no one answering, and just recently where someone suggested i try this site. Any advice would be appreciated. thanks.

Bulldog list the door trigger wire as: purple (-) @ DASH FUSEBOX, PIN 21 IN WHITE 30-PIN PLUG(A) http://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.aspxWhen all else fails, Read the Instructions

Support the12volt.com Make a Donation

Thanks. Would you suggest i dont try to hook up the wire to the dome light supervision?

Found this on a different web site. You could try the dome light supervision light. The listing below are for each door trigger. I don't know why the left rear is listed in the drivers kick panel. Could be an error. What wire is totally correct? Left Front Door Trigger: purple (USA/CAN made); white (JPN made) dash fuse box, white 30 pin plug (2A), pin 21 Right Front Door Trigger: beige (USA/CAN made); brown (JPN made) dash fuse box, white 32 pin plug (2E), pin 20 Left Rear Door Trigger: black (USA/CAN made); lt. blue (JPN made) driver kick, white 13 pin plug, pin 10 Right Rear Door Trigger: yellow (USA/CAN made); lt. green (JPN made) dash fuse box, white 32 pin plug (2E), pin 19 Dome Supervision: gray (USA/CAN made); white (JPN made) dash fuse box, white 6 pin plug (2K), pin 2When all else fails, Read the Instructions

Support the12volt.com Make a Donation